.
• (4)
.
(1)
'R' .
.
.
-
, (5)
‘DRILL BIT’
.
-
, (5)
‘HAMMER’.
.
.
.
,
.
.
- .
. E
• on/off (2) .
.
• on/off (2)
• (1)
.
.
.
/ (2) . !
.
. F
FCD-2400 I.
• (7)
(9) .
• .
“ ” (10)
• (11),
" # $
$ 10 °C
40 °C.
.
, 1 - 2
.
4 – 5 .
% #$
, #
. #$ -
# $ . $
$ .
Ferm 53
recognised dealership.
10. Always unplug the charger before cleaning or
carrying out any other maintenance on it.
11. Do not attempt to charge the battery pack in
temperatures of below 10 degrees or above 40
degrees centigrade.
12. The air vents on the battery charger must be kept
unblocked.
13. The battery pack must not be short-circuited.
When an apparatus short-circuits, the strength of
the electric current is increased. This can cause the
apparatus to over heat, catch fire or even explode, causing
damage and also endangering the operator.
To avoid this;
1. Firstly do not connect any wires to the terminals
of the battery pack;
2. Ensure that no metal objects (nails, coins, paper-
clips) are caught in the opening of the battery
pack;
3. Do not expose the battery pack to water or rain.
14. If the battery pack is broken or can no longer be re-
charged it must be properly disposed of.
15. Never throw the battery pack into water or a fire – it
may explode.
MOUNTING ACCESSORIES
Prior to mounting an accessory always remove the
battery.
Inserting and removing the drill bits.
Fig. B
In addition to bits the machine can also hold screw bits
with a hexagonal shaft.
• Loosen the chuck (5) by holding one section and
turning the other.
• Position the drill bit shaft in the take up of the chuck.
• Fasten the chuck until the drill bit is tight.
• Open the chuck again when you want to exchange
the drill bit.
Inserting and removing of the battery
Fig. C
• Make sure that the direction switch (1) is in middle
position to prevent the machine from switching on
unexpectedly.
• Place the accumulator (7) in the bottom of the
machine, as shown in the diagram, until it engages.
• Before removing the accumulator, depress the
release buttons (8) and then take the accumulator
out from the bottom of the machine
The drill must only be used with the forward /
reverse switch fully enclosed
OPERATION
Fig. D
Always observe the safety instructions and
applicable regulations.
Firmly hold the machine and push the bit with even
pressure into the workpiece. Do not force the machine.
Use only bits that do not yet show any signs of wear.
Worn bits have a negative effect on the efficiency of the
machine.
Torque adjustment.
The machine has different torque settings by means of
which the force for fastening and loosening screws can
be determined.
• Put the torque setting ring (4) at the required torque.
• Preferably select the lowest possible setting to move
the screw. Select a higher torque setting when the
motor is slipping.
Screwing screws in and out.
• Set the direction switch (1) on position 'R' for putting
in screws.
• Set the direction switch on position 'L' for removing
screws.
Drilling
• Turn the torque setting ring (4) to drilling position.
Be sure that the direction switch (1) always in
position 'R' during drilling.
4 Ferm
