(FTC-1440K2) 14.4 V
—
- - -
230 V~
50 Hz
1.2 Ah (NiCd)
3 - 5
2
0-400/0-1150
/
0.8 - 10 mm
20 mm
10 mm
13 mm
1.66 kg
Lpa ( ) 66.28 dB(A)
< 2,5 m/s
2
.
.
EN 60335,
.
()
.
.
,
. 1.5
mm
2
. ,
.
1
2
1
1
2
1
1
1
,
.
(.)
1 /
2
3
4
5
6
,
.
(.B)
,
.
• (5b)
(5a).
• .
•
.
•
.
(.)
• (2)
,
.
•
, ,
. ,
90.
.
• ,
(6)
.
56 Ferm
OPERATION
Always observe the safety instructions and applica-
ble regulations.
Firmly hold the machine and push the bit with even pres-
sure into the workpiece. Do not force the machine.
Use only bits that do not yet show any signs of wear.
Worn bits have a negative effect on the efficiency of the
machine.
ADJUSTING THE SPEED (Fig.D)
The machine has two different drilling speeds.
• Set the speed selection switch (3) on position '1' for
drilling at a low speed.
• Set the speed selection switch on position '2' for dril-
ling at high speed.
TORQUE ADJUSTMENT (Fig.E)
The machine has different torque settings by means of
which the force for fastening and loosening screws can be
determined.
• Put the torque setting ring (4) at the required torque.
• Preferably select the lowest possible setting to move
the screw. Select a higher torque setting when the
motor is slipping.
Screwing screws in and out
• Set the direction switch (2) on position 'R' for putting
in screws.
• Set the direction switch on position 'L' for removing
screws.
Drilling
•Turn the torque setting ring (4) to drilling position.
Be sure that the direction switch (2) always in posi-
tion 'R' during drilling.
SWITCHING ON AND OFF (Fig.F)
• Press the on/off switch (1) in. You regulate the speed
of the machine by the degree to which you keep the
switch pressed in.
•Releasing the on/off switch (1) causes the drill to stop
immediately
• Slide the direction switch (2) to the middle to lock the
machine in switched off mode.
Do not put the machine away until the machine has com-
pletely stopped running. Do not store the machine on a
dusty surface. Dust particles can get into the mechanism.
CHARGING BATTERIES (Fig. G)
The enclosed battery charger has been exclusively de-
signed for loading batteries of the FTC-1440K2.
• Position the battery in the battery charger as indica-
ted in the illustration.
• Plug in the battery charger. The red “fast charging”
light is then illuminated
•As soon as the green light is illuminated, charging has
finished and the accumulator is ready for use
Only use the battery charger in a dry environment at
a temperature between 10 °C and 40 °C.
The accumulator on the drilling machine you have pur-
chased is not charged up. Before using it for the first time
leave it to charge for 5 - 7 hours in order for it to reach its
full capacity.
The total capacity of the accumulator will be reached af-
ter it has been charged 4 – 5 times.
Ferm 5
