5. VOL- VOL+ Used to change the volume level (lower, higher).
6. Menu navigation.
7. ENTER Confirm changes
8. SETUP Displays the main menu on-screen.
9. OPEN Open DVD loader
10. SD/MMC/MS Flash card reader
11. USB Port for connecting an external USB memory device.
12. AV OUT CVBS video + stereo audio output
13. Minijack Earphone Socket
14. COAXIAL Digital coaxial SPDIF audio output.
15. ON/OFF: Turn the Ferguson on or off
16. DC IN 9-12V Power socket
17. ANT IN: Input of the concentric cable from the DVB-T2 antenna.
18. HDMI: Digital image and sound output to HD TV.
6. DVB-T2
6.1 Connecting an aerial
In order to check the correctness of connection of external equipment, for example a terrestrial
antenna, read the installation manual or hire a professional technician!
Good reception is conditional on the precise placement of the antenna. Even the best antenna
will cause reception problems if it is incorrectly adjusted. Even slight placement errors may
render reception impossible or considerably impair image/sound quality. Before installation
make sure that the location is suitable. The proper direction may be initially determined by
making a comparison with other antennas. There should be no objects directly in front of the
antenna, for these may block the signal from reaching the bowl! Once you select an optimal
location for the antenna, fix and adjust it initially, and then proceed to a precise adjustment.
Each antenna is fitted with regulating screws that make it possible to correct its vertical and
horizontal placement.
Adjusting is somewhat more difficult in the case of digital tuners. You cannot perform
adjustments on the basis of the image, because this appears with a certain delay. What is more,
the indicators available in the settings menu also act with a delay, and therefore adjustment
may take considerable time and be very imprecise. An antenna signal meter will be
indispensable for setting up the antenna. The meter must be connected to the antenna cable
between the antenna and the receiver. We strongly recommend hiring a professional technician!
6.2 Auto search
Switch to DVB-T2 mode – press SOURCE and then select “DVB-T2 HDplay” from the menu.
Press SETUP. Go to “Channel Search” and select “Auto search”. In this menu, you can search for
channels automatically - the receiver searches only frequency by frequency according to the
saved list of DVB-T2. This list can not be edited in a separate menu.
6.3 Recordings
Switch to DVB-T2 mode – press SOURCE and then select “DVB-T2 HDplay” from the menu.
To view recordings press SETUP. Go to “USB” then “Multimedia” and select “PVR”.
This tab is used to play back recordings made using the receiver.
10