12
MULTIMASTER FMM 250 / MULTIMASTER FMM 250 Q
EN
Changing the tool.
The application tool can be fastened offset at convenient working positions at 45°
steps (or at 30° steps for the triangle-shaped sanding pad).
M
ULTIMASTER FMM 250 Q (Figure 3).
Before mounting or replacing
application tools or accesso-
ries, pull the power plug. This preventive
safety measure rules out the danger of inju-
ries through accidental starting of the
power tool.
For all work or when chang-
ing application tools, always
wear protective gloves. Danger of injury
from the sharp edges of the application
tools. Application tools can become very
hot while working. Danger of burns!
➤ Loosen the quick-clamping lever
and swivel it to the stop.
➤ Pull out the fastening element.
➤ Clean the tool holder, the applica-
tion tool and the fastening element.
➤ Place the application tool exactly
onto the star-shaped tool holder. Pay
attention that the application tool has a
flush fit.
➤ Insert the fastening element to the
stop into the tool holder.
➤ Swivel the quick-clamping lever back
until it engages.
Protect your hand and fin-
gers from being bruised/
crushed from the snapping back quick-
clamping lever. The quick-clamping lever
pivots back powerfully due to the spring
force.
WARNING
CAUTION
CAUTION
180°
Fastening element
Tool holder
Quick-clamping lever
Fig. 3
3 41 01 091 21 0.book Seite 12 Dienstag, 24. Juli 2007 3:32 15
