500338
24
Verklein
Vergroot
Pagina terug
1/32
Pagina verder
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity supply before servicing. Check appliance is safe when you have finished.
Page 24
Installation and
Servicing Instructions
This appliance must be installed and serviced by a
competent person.
IMPORTANT
The unit shall be installed in accordance with the regulations
in force at the time. Read the instructions thoroughly before in-
stallation and subsequent use.
In the UK, regulations and standards are as follows -
BS 6891 :1988
Health And Safety At Work etc. Act
BS 7671 I.E.E. Regulations for Electrical Installations
Local and National Building Regulations
Electricity at Work Regulations
Fire Precautions Act
The appliance has been CE-marked on the basis of compli-
ance with the Low
Voltage and EMC directives for the voltage stated on the data
plate.
WARNING - ALL APPLIANCES MUST BE EARTHED
On completion of the installation, this manual should be left
with the Engineer-in-Charge for reference during servicing.
Further to this, The Users Manual should be handed over to
the Owner, having had a demonstration of the operation and
cleaning of the unit.
IT IS IMPORTANT THAT THESE INSTRUCTIONS BE
CONSULTED PRIOR TO INSTALLING AND COMMIS-
SIONING THIS APPLIANCE.
FAILURE TO COMPLY WITH THE SPECIFIED PROCE-
DURES MAY RESULT IN DAMAGE OR THE NEED
FOR A SERVICE CALL.
SECTION 1 - INSTALLATION
UNLESS OTHERWISE STATED, PARTS WHICH HAVE
BEEN PROTECTED BY THE MANUFACTURER ARE
NOT TO BE ADJUSTED BY THE INSTALLER.
1.1 MODEL NUMBERS, NETT WEIGHTS AND
DIMENSIONS
Model Width Depth Height Weight
211-EEO 1100mm 600mm 935mm 140kg
1.2 SITING
1.2.1 Positioning the Appliance (see Figure 1)
Figure 1
The unit is supplied with two rear and one centre front roller for
movement purposes.
To position the range, first remove the kicking strip from the bot-
tom front of the unit. Pull open the drawer to the furthest point
and lift and pull it forward to remove. The screw that lowers the
front roller is positioned at the LH side of the drawer opening on
the centre support beam.
Place the flat end of the spanner over the square drive peg and
turn this clockwise until the front beam and feet are clear of the
floor. Use the hex end of the spanner to turn the two adjusting
nuts, positioned at either bottom front corner. Six complete turns
clockwise will lower the back rollers and raise the unit rear.
The unit may now be pushed into position.
THE APPLIANCE MUST NOT BE PUSHED, PULLED OR
LIFTED BY THE TOWEL RAIL OR DOOR HANDLES.
24

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Falcon 211 EEO Ceramic bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Falcon 211 EEO Ceramic in de taal/talen: Engels als bijlage per email.

De handleiding is 0,94 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info