Handleiding Fakir MAGIC STEAM BASIC (pagina 9 van 24) (Engels, Turks)

565841

Verklein

Vergroot

Pagina terug

1/24

Pagina verder

The accessories holder (16) allows you to fix the tube

with the brush mounted on it on the body of the appliance.

To attach the hose to the appliance, slide the hook on

the hose into the accessories holder slot on the appliance

(Fig. 9).

Use of the accessor›es holder

Pull the elbow tube (27) away from the net filter housing

(26) until it is removed (Fig. 11a).

Take all the components apart and rinse themin running

water. If the filter sponge has any tears, replace it.

A cleaning brush (20-A) is supplied for easy cleaning of

the dirt container (20); use it also to clean the appliance’s

hose connections and the inside of tools.

NOTE: Do not use the brush for cleaning theoutside of

the appliance If you wish to continue working, top up the

level

of the water. Put the “EcoActiveFilter” water filter assembly

(23) back into the dirt container (20).

ATTENTION: Make the arrow on the elbow tube (27)

coincide with the mark on the net filter housing (26)

(Fig.11b). Put the dirt container (20) back in its place as

described in the “preparation for use” paragraph.

NOTE: Make sure you empty the dirt container (20)

before putting your Magic Steam Vac Basic away. One

of the great advantages of this appliace is precisely the

fact that it is possible to put it away clean.

How to clean the bucket

All Magic Steam Vac Basic accessory tools can be connected

to the handle (A2) or to the extension tubes (D).

To connect accessories for suction and steaming

(D-E-K-N) proceed as follows:

• Connect the handle or the extension tube to the required

accessory until the connector button (C) is hooked (Fig. A)

• To disconnect the accessory, just keep the connector

button pressed (C) and separate the two parts (Fig. B)

WARNING: in this situation, it is important not

to press the steam button (A3), to avoid steam

coming out accidentally.

Connection of accessories

This appliance can be used to suck up dust or liquids

equally easily.

However, if the water in the filter is very dirty it should be

replaced proceeding as described in the section “Emptying

and cleaning the dirt container”.

When the dirt sucked in reaches the maximum permitted

level in the Dirt container (20), suction is stopped automatically

by the safety float provided for this purpose (you will notice

that the engine speed has increased).

ATTENTION: Switch off the appliance, and only switch

on again after restoring the water level in the conteiner as

described in the “emptying and cleaning the dirt container”

paragraph.

IMMEDIATE RESTART WITHOUT RESTORING

THE WATER LEVEL CAN DAMAGE THE AIR

OUTLET FILTER.

EMPTYING AND CLEANING THE WATER

CONTAINER

Switch off the appliance at the main switch (1) and disconnect

the supply cable from the mains.

Lift the dirt container (20) out of its compartment by the

container handle (22) (Fig.3). Turn the handle and take

out the “EcoActive-Filter” water filter assembly (23), as in

picture 4. Empty the container tilting it towards the small

groove (Fig. 10).

Suction of solids and liquids

Suction up about one and a half litres of clean water,

turning on the suction for a few seconds.

The whirlpool created inside the bucket will rinse the

walls and dislodge any dirt. Clean water cleans the

inside of the tubes as it passes through them. Now

empty the bucket again and put your appliance away.

TIP FOR USING THE ACCESSORIES

DO NOT USE STEAM FUNCTION ON DRAYLON,

VELVET, LEATHER OR OTHER SENSITIVE

SURFACES.

If in doubt about the effect of steam on other surfaces,

always proceed only after carrying out a test on a

hidden part or a sample. Allow the area treated with

steam to dry and then check whether any changes in

colour or deformations have occurred before proceeding

further, ensuring exactly the same steam power and

distance as in the test.

When cleaning wooden surfaces (furniture, doors, etc.)

and brick floors always proceed with caution since

excessive use of steam could damage the wax, the

polish or the colour of the surface to be cleaned. It is

therefore advisable to apply the steam to these surfaces

only for short periods at a time or to clean them with

a cloth that has been treated with steam. On particularly

delicate surfaces (e.g. synthetic materials, enamelled

surfaces, etc.) we strongly recommend using the steam

at its lowest output power.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Fakir MAGIC STEAM BASIC Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info