EN
Page | 20
14 Operation
Fitting the suction tube,
see figure
1. Push the suction tube with the
thicker end onto the connection
on the appliance.
2. Connect the other end of the
suction tube to the nozzle.
To disconnect the suction pipe:
1. Press the release button (top
and bottom 6/8)
2. Pull out the suction tube.
Note
• Make sure that the battery is
charged before using the
appliance.
• The appliance does not function
efficiently with a weak battery.
Charging the appliance
1. Charge the appliance with the
supplied adapter (16).
2. The 4 LEDs blinking blue during
charging.
The 4 LEDs light up blue as soon as
the appliance is charged.
Charging time approx. 4-5 hours.
If the LEDs light up red, the suction
power is weak and the battery is almost
empty. Recharge the appliance.
Use of the appliance
1. Switch the appliance on at the
ON/OFF (4) button.
2. Adjust the suction power from
normal to strong with knob (2).
Note
• Make sure that the battery is
charged before using the
appliance.
• The appliance does not function
efficiently with a weak battery.
Emptying the dust
container
1. Disconnect the dust container from
the appliance.
2. Hold the dust container over a
waste bin.
3. Empty the contents of the dust
container into the waste bin. To do
so, push the opener of the dust
container downwards to open the
base plate.
4. Close the base plate again. The
lock on the dust container must
engage audibly.
15 Cleaning and service
The filter system
Your appliance has 2 filters (motor filter
and air filter).
• The conventional dust bag system
has been replaced with a
transparent dust container
• in which coarse dirt and very
small suspended particles are
removed from the intaken air
• by the high flow velocity.
• The purchase of dust bags is
therefore no longer necessary.
• Clean the filters at regular
intervals.
•
ATTENTION
• Never wash the filters in the
washing machine.
• Do not use a hair dryer for
drying.
• Put the appliance into operation
again only when all the
• filters are completely dry and
correctly installed.
Cleaning the motor
(See Figure 8/9 12)
1. Press the release button and at
the same time pull out the
container using the handle (1).
2. Tip the dust out of the container
by opening the cover with the
release button.
3. Remove the central plastic filter
from the bracket by turning it in
anti-clockwise direction. If you
wash the plastic filter, allow it
to dry thoroughly before
installing it again.
4. Remove the motor filter and
wash it by hand with cold
water.
5. Allow it to dry completely at
room temperature.
6. Install the motor filter again.