9.5.1 Fumetemperature sensor alarm
The alarm is triggered when the fume temperature sensor is damaged or disconnected. The exhaust and exchanger
blower speed is increased to its maximum value and the Auger motor is switched off, interrupting pellet loading. The
blower remains on for approximately 10 minutes.
9.5.2 Fume overheating alarm
The alarm is triggered whenever the fume sensor detects a temperature exceeding 220°C. The message “alarm hot
temp” appears on the display. The exhaust blower speed is increased to its maximum value and the Auger tube motor is
switched off, interrupting pellet loading. The blower remains on for approximately 10 minutes.
9.5.3 Ignition failure alarm
The alarm is triggered at the second ignition failure, i.e. when the stove does not reach the required ignition temperature
twice (a 3°C/ minute gradient is necessary). The message “alarm no fire” appears on the display. The stove enters the
switching off phase which is completed in approximately 10 minutes, as with the other alarms described above.
9.5.4 Stove switching-off during working modealarm
The alarm is triggered when the flame goes out and the fume temperature falls below the stove minimum working
threshold. The message “alarm no fire” appears on the display and the stove switches off.
9.5.5 Negative pressure alarm
The alarm is triggered when the chimney or the fume outlet are clogged.
9.5.6 General safety thermostat alarm
If the general safety thermostat detects a value exceeding the trigger threshold, it
immediately switches off the Auger tube (to which it is connected in series), while
the control board acquires this change in status through the AL1 clamp in CN4.
The message
ALARMSIC
is displayed.
Unscrew the black cap on the back of the stove and press the button to reset the
contact.
