Store pellets in a cool and dry place. Storing pellets in a damp or too cold place may reduce the stove potential
heat output. Be careful when storing and handling pellet bags to prevent pellet crushing and sawdust
production.
Clean the burn pot on a regular basis upon every ignition or pellet refuelling.
Open the firebox only upon refuelling or removal of residues to prevent fumes from escaping.
Do not switch the stove on and off intermittently to avoid damaging its electrical and electronic components.
Do not use the appliance as waste incinerator or for any other purpose other than the intended one.
Do not use liquid fuels.
Do not modify the appliance without prior authorisation.
Use only original spare parts recommended by the manufacturer.
The fuel consists of small cylinders with 6-7mm diameter and a maximum length of 30mm. Their maximum moisture
content is equal to 8%. This stove is designed to burn pellets made of compacted sawdust obtained from different types of
wood, in compliance with environment protection legislation.
The use of different types of pellets may result in a slight, sometimes even undetectable, change in the stove efficiency.
This change can be counterbalanced by increasing or decreasing the stove heat output by only one step.
Make sure that the stove is transported in compliance with safety regulations. Avoid any improper transfers or knocks
that may damage the ceramics or the structure.
The metal structure is coated using high temperature paints. When switching on the stove for the first times,
unpleasant odours may be emitted as the paint starts to harden on the metal parts. The fumes emitted are not
harmful. Ventilate the room to evacuate them. After the first heating cycles, the paint will reach its maximum adhesion
and all its chemical and physical features.
The hopper can contain up to 15 kg of pellets. Open the lid and pour the pellets to load it, also during normal
operation, making sure that no pellets fall out of it. Always refuel the hopper before leaving the operating stove
unattended for long periods of time.
Whenever the hopper and the Auger tube get completely empty, the appliance will be automatically switched off. It may
take two separate ignitions to resume operation at ideal working conditions since the Auger tube is very long.
CAUTION! If the stove is not properly installed, power outages may result in fume spillages.
Under specific circumstances, an uninterrupted power supply unit must be installed.
CAUTION!
Being a heating appliance, some parts of the stove can become extremely hot. We therefore recommend
paying special attention during operation.
WHEN THE STOVE IS WORKING:
do not open the door;
do not touch the door glass since it becomes extremely hot;
keep children away from it;
do not touch the fume outlet;
do not pour any liquid inside the firebox;
do not perform any maintenance operations if the stove is not cold;
only qualified technicians are allowed to perform any operation;
follow all the instructions contained herein.
