668834
30
Verklein
Vergroot
Pagina terug
1/55
Pagina verder
Ventilation speed is proportional to operating power and cannot be modified independently with
respect to stove power.
In channelled air models, the stove has two rear hot air outputs, one on the right and the other on
the left, under the pellet tank. Each of the two outputs has an independent control menu (see
chapter 7 menu).
6.3.7 Circulator (hydro and boiler models)
Hydro models have a circulator and an expansion tank for direct connection of the system stove
to radiators. The circulator starts as soon as water reaches a temperature of 55° C (value that must
not be lowered to prevent formation of condensation in the stove) and works according to water
temperature, even with the stove off. A bleed screw is available on the back of the stove to remove
any air in the circulator itself.
6.3.8 External thermostat
Stove operation can be adjusted to any external room thermostat connected to the circuit board
(see electrical diagram). The thermostat connection is made using a 2x0.5 mm2 cable. This
operation should be performed by qualified personnel.
The external thermostat works in parallel to the internal thermostat of the stove. To work the
external thermostat exclusively, set room temperature to minimum (7° C). At this point, stove
modulation will be controlled by the external thermostat.
During the working phase, if the room temperature is lower than the set temperature and the
external thermostat is active (closed contact), the stove will operate at the set power level. When
the room temperature reaches the set temperature, (external thermostat contact open), the stove
will go to minimum power and the display will show the message "MODULATE". This modulation
has been completed only if the room temperature returns to being lower than the set temperature
in the external thermostat.
Ambient
sensor
Thermostat
6.3.9 Brazier cleaning
During normal operation in work mode, "BRAZIER CLEANING" is activated at set intervals for a
duration of about 45 seconds. During this time, the display will show the message "BRAZIER
CLEANING", stove ventilation increases and the flame lowers in the brazier. This operation is
necessary to decrease the likelihood of ash accumulation of ash inside the brazier.
If you notice an excessive accumulation of pellets in the brazier (over half the level of the
brazier itself), immediately switch off the stove and clean the brazier. Promptly contact a
service centre.
6.3.10 Shutdown
To turn off the stove, hold button 4 for a few seconds .
Once the shutdown signal has been received, the display will show a "FINAL CLEANING"
message and the fume exhaust fan will continues to run at full speed for a minimum time of about
10 minutes to ensure complete cooling of the stove. The hot air fan will also continue to run until
the stove cools down.
CAUTION: Never disconnect the power supply at this stage, as this may create problems
for the stove and compromise the subsequent phases of ignition.
30

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Eva Calor Hydro Slim 16 kW bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Eva Calor Hydro Slim 16 kW in de taal/talen: Engels als bijlage per email.

De handleiding is 5,06 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info