668826
34
Verklein
Vergroot
Pagina terug
1/47
Pagina verder
04. PRODUCT USE
33
User functions
Standard functioning of a control board properly installed on a forced air pellet stove is described below with reference to the
functions available to users. The indications listed below refer to a control board fitted with programmable thermostat.
Before switching on the stove, the display is as in figure 16.
fig. 16
Stove ignition
Make sure that there are pellets in the hopper, that the burn pot is correctly positioned and clean from any combustion residues and
then close the door.
Hold down P4 for a few seconds to switch on the stove. The display shows that the stove is on.
Start-up phase
The stove performs all the steps of the start-up phase according to the parameters concerning its levels and times. The display will
show the wording ON, as there is no pellet loading but the fume fan is operating. PELLET LOADING state will occur where the pellets
are being loaded into the burn pot. Once the pellets have started to burn and the fume temperature is increased, the display will show
FIRE ON, a transition phase between ignition and operating power.
Ignition failure
The alarm is triggered when, after the period of time set by Pr01, the fume temperature has not reached the minimum value permitted
(Pr13 parameter) with a gradient equal to 2°C/min.
If there are unburned pellets inside the burn pot, it is necessary to empty the burn put before switching on the stove again. This will
avoid wasted pellets and possible spillage within the combustion chamber.
If the pellets have begun to burn but the alarm state persists, wait until all the pellets are burning and then switch on again.
Check that there are pellets inside the hopper.
Stove operational.
At the end of the start-up phase, if no problems occurred, the stove enters its normal working mode.
If the temperature of the stove is the same as that set, the pump will come on.
Changing set room temperature
Press the P2 button to change the set room temperature. The display shows the current SET temperature state as in figure 19.
fig. 19
34

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Eva Calor Hydro 20 kW bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Eva Calor Hydro 20 kW in de taal/talen: Engels als bijlage per email.

De handleiding is 4,1 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Eva Calor Hydro 20 kW

Eva Calor Hydro 20 kW Gebruiksaanwijzing - Nederlands - 90 pagina's

Eva Calor Hydro 20 kW Gebruiksaanwijzing - Deutsch - 38 pagina's

Eva Calor Hydro 20 kW Gebruiksaanwijzing - Français - 43 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info