the device, cable or plug in water or any other fluid and never touch
device with wet hands.
5. If the device is installed in a bathroom, it must be installed such
that the switches and other operating components cannot be
touched by a person in the bath or shower.the ground, whether
secured to the wall or ceiling.
6. The wall to which the device is secured and the ceiling and walls
within 1 metre of the device must not be made of flammable
materials. Materials must be resistant to temperatures of at least
125°C without burning, melting, deforming or bursting into flames.
Check regularly to ensure that the wall and ceiling are not
overheating; this could be dangerous!
7. Only use the device if it has been secured properly. Make sure that
you always use attachment materials that are suitable for the
surface you are working with; consult an expert if required.
8. With wall installation: never block the space between the device
and the wall.
9. Never install this device behind a door or by an open window,
where rain could get in.
10. If this device is connected directly to your electrical installation, it
must be installed by a specialist, taking into account the valid
regulations/legislation.
11. The installation must be equipped with a double pole switch with a
minimum contact opening of 3 mm.
12. Do not place the device near, under or facing an electrical socket
and not in the vicinity of an open fire or heat source.
13. Do not use the device nearby or facing furniture, curtains, paper or
other flammable materials. Keep at least 1 metre from device!
14. Do not use the heater outdoors or in areas that are smaller than 5
m³ (Sani-Towel 500) and 7m³ (Sani-Towel 750).
15. The device contains hot and/or glowing and sparking components.
Do not, therefore, use where fuels, paint, flammable fluids and/or
gases are stored. Do not use the device in an environment that
poses a fire risk, e.g. near gas tanks, gas pipes or aerosols. This is
an explosion and fire risk!
Warnings - use
1. Do not use additions/accessories on the device that have not been
supplied or approved by the manufacturer.
2. Only use the device for its intended purpose and in the manner set
out in this instruction leaflet.
