Attach the feet supplied to the underside of the heater (see picture):
Turn the heater upside down. Place a blanket (or something similar) under the
heater to prevent damage!
Slide the feet into place on the sides, exactly along the gaps. This will ensure
that the threaded holes will align correctly.
Securely attach the feet to the heater using the self-tapping screws.
Return the heater to the upright position.
Set-up and operation
Make sure the heater is turned off (mode selector dial to 0W) and that the
thermostat dial is set to maximum (clockwise, as far as it will go). Now plug into
an earthed, correctly functioning 220-240V / 50Hz socket. The pilot light will
switch on.
Turn the mode selector dial to the desired position:
750W = low power heating (750 Watt)
1250W = medium power heating (1250 Watt)
2000W = full power heating (2000 Watt)
The heater will now start to heat the space.
When the space has reached the desired temperature, turn the thermostat dial
anticlockwise slowly until you hear a click. In this position, the thermostat will
maintain the current temperature by turning the heater on and off for a top-up,
if necessary. If so desired, you can now switch to a lower power level. For
higher temperatures, turn the thermostat dial clockwise, for lower temperatures
anticlockwise.
To switch off the heater turn the mode selector dial to 0W and unplug.
Safety features
Tipping safeguard
The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. The heater will function as normal once it is
returned to its upright position but you are advised to switch if off, unplug and
check it for damage before using again. Do not use the heater in case of damage or
malfunctioning. Have the appliance inspected/repaired!
