General safety instructions
1. Before using the machine, carefully read this entire instruction manual.
2. Before using your new heater, check it, including cord and plug, for any visible
damage. Do not use a damaged heater, but send it back to your dealer for
replacement.
3. Do not use the heater until it is been fully installed in accordance with the
instructions under the heading ‘Description, Composition and Installation’.
4. This heater is strictly intended for normal domestic use. Only use it for the
(additional) heating of your home.
5. This heater is in principle suitable for use in wet or damp rooms such as bathrooms,
washrooms, etc. (IP24). Keep it at least 60 cm. away from water points and make sure
that it can never fall into water and that no water can enter the stove. Should this
ever happen, take out the plug from the socket first! Do not use an internally wet
stove again but offer it for repair. Never immerse the heater, cord or plug in water or
other liquids and never touch the heater with wet hands.
6. The supply voltage and utility frequency, specified on the machine, need to match
those of the socket that is used. Only use an undamaged, earthed socket that is
secured with a 30 mA earth leakage circuit breaker. The electrical socket that you are
using must be to hand at all times in order to be able to remove the plug from the
socket in the event of an emergency
7. Fully extend the cord before plugging in the heater. Make sure it does not come into
contact with any part of the heater and prevent it from heating up any other way. Do
not run the cord underneath carpeting; do not cover it with mats, carpet strips or
similar and make sure it is not placed in any passageways. Make sure the cord cannot
be stepped on and that no furniture is placed on top of it. Do not lead the cord
around sharp corners and do not roll it up too tightly after use!
8. If possible, do not use an extension cord, as this poses the risk of overheating and
fire. If the use of an extension cord is unavoidable, then make sure it is an
undamaged, approved extension cord with a minimum diameter of 2 x 1.5 mm² and a
minimum permissible power of 1000 Watt. To prevent overheating, always fully
extend the cord!
9. During use the plug can feel a little warm, that's normal. Is it really warm, then there
is probably something wrong with the socket. Contact your electrician.
10. Do not use the heater outdoors and do not use it in spaces, smaller than 7 m³.
11. A heater contains hot and/or glowing and sparking components. Do not, therefore,
use it in areas where fuels, paint, flammable liquids and/or gasses etc. are stored.
12. Do not place the heater near, under, or directly opposite a socket and do not place it
near an open fire or other heat source.
13. Do not use the heater near or directly opposite furniture, animals, curtains, paper,
clothes, bedding or other inflammable objects. Keep them at least 1 metre away from
the heater!
14. Never cover a heater! Never use the heater to dry clothes and do not place anything
on top of the heater. Do not let anything lean against the heater.
