Starting and operating
Make sure that the socket to which you want to connect the dehumidifier has the same
voltage as stated on the rating plate: 220-240V ~ 50Hz.
Plug it into the socket; the device beeps.
Press the on / off button. The display shows the "operating symbol" and the current
humidity. When the "in operation symbol" flashes, the humidity is lower than the set
humidity.
Press the humidity up or humidity down button to set the percentage of the humidity.
Each time you press the humidity up and humidity down buttons, you set the desired
humidity to 1% higher or lower. If the set humidity is more than 3% lower than the current
humidity, the device starts operating until the current value is 3% lower than the set
humidity. Then the device turns off.
If you set the humidity to less than 30%, the device will continuously dehumidify. The
display will then show “CO”.
The appliance is equipped with an hour meter, which counts how many hours your
appliance has worked in total (in units of 10 minutes).
Press the ON/OFF button again in order to switch the device off. The device will come to a
halt and the display goes out.
Note:
If the set humidity is higher than the actual humidity, the device will not come on.
If you are dehumidifying, the fan motor and the compressor will run for at least three
minutes before the compressor starts. The compressor may not be restarted within
three minutes of switching the device off. It is, therefore, possible that the motor will
not immediately respond to being turned off or on!
When the temperature is low, keep an eye on whether the device needs to defrost.
When defrosting, the relevant light will come on and the fan will run but the
compressor will automatically switch off.
The devices have an automatic memory that automatically stores the settings and also
saves if the power supply fails or is interrupted. Once the power supply has been
restored, the device will start to work according to the previously entered settings.
The display will show a humidity level of 30% to 90%.
Remove the plug from the socket if you do not plan to use the device for an extended
period.
If the water collecting tank is full, the light will come on and the compressor and fan will
automatically shut down. You will also hear a beep. If you do not drain the water
collection tank, the beep will be repeated every 5 minutes. Only once the water
collection tank has been emptied can the device be used again.
You can install a continuous drain by removing the water collection tank, taking the
rubber bung out on the side of the water collection tank and connecting a hose to this
outlet. Then replace the water collection tank and run the hose from the device
(downwards) to a suitable drainage point.
