The heater can rotate through approximately 60°; the recommended
beam angle is 45°, see image. When adjusting the angle ensure
that the radiator does not radiate heat onto flammable materials
from a short distance!
Fasten all screws another time firmly and scheck or the heater is
firmly mounted. Now your infra red heater is ready for use.
For personal protection the installation, to which the EUROM HEAT
AND BEAT is connected, has to be equipped with an earth fall
device (max. 30 mAmp). Only connect the heater to an earthed
socket!
Under some circumstances it may be attractive to make a fast connection between the heater
and the main supply, and to operate the heater with a switch. Because the EUROM HEAT AND
BEAT has a high water tightness (IP65) and for safety reasons, such a connection has to be
made by a qualified electrician.
WORKING
Check for every use:
- or the appliance doesn’t show signs of damage.
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating duet o wind
or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220-240V-50Hz) and is grounded.
If everything is all right you can insert the plug into the socket.
The HEAT AND BEAT has a remote control that works with two batteries: AAA, 1.5V.
While using, point the remote control to the receiving point of the heater. If there are obstacles
between remote control and the heater, it will not work! The commands from the remote control
to the device can cover a maximum distance of 6 metres.
Press the on/off switch (5) on the side of the unit to "I" (on); The blue light on the reception
point will go on.
Set the device into operation by pressing the ON button of the remote
control. The device has a ‘slow start’ at 33% output. 4 seconds after
starting, it automatically switches to the most recently used output. On
first use, it will switch to 100% output after 4 seconds.
By pressing you can switch to a higher heating level.
By pressing you can switch to a lower heating level.
By pressing (briefly) you can switch the speaker on (or off).
By pressing this button for longer you can initiate the Bluetooth
connection for the speakers.
By pressing you can switch on the LED lighting.
By pressing you can switch off the LED lightning.
To stop the unit, first press the 'off' button on the remote control. Then
turn it off by pressing the on/off-switch (5) to ‘O’ (off). Finally, unplug it
from the wall outlet. Allow the heater to cool down.
