3. Make sure that the cord not hangs over (sharp) edges, not makes
strong curves, not can be pulled along and not touches hot
surfaces. Fully extend the cord before plugging in the heater. Do
not run the cord underneath carpeting; do not cover it with mats,
carpet strips, or similar and make sure it is not placed in any
passageways. Make sure the cord cannot be stepped on and that
no furniture is placed on top of it. Do not lead the cord around sharp
corners and do not roll it up too tightly after use!
4. Don’t locate the appliance just above or below a wall socket.
5. Keep all flammable things as furniture, curtains, cloths, paper etc.
away from the appliance (at least 1 meter). Don’t place the device
on a soft surface such as a bed.
6. Despite of the fact that the HEAT AND BEAT TOWER is very
watertight, you have to be careful with water. This device is not
suitable for use in bathrooms, washing areas or similar rooms in the
home. Make sure that the HEAT AND BEAT TOWER cannot fall
into water and don’t expose it to heavy water beams. Don’t touch it
with wet hands. The heater is to be installed so that switches and
other controls cannot be touched or operated from the pool, bath or
shower.
7. In order to avoid overheating and fire hazard, do not cover or
obstruct the appliance. Do not put any of the following materials on
the appliance, such as clothes, blanket, pillow, paper etc. For
example, do not place any candles on the device. The minimum
distance 1 meter between the appliance and flammable materials
must always be maintained.
8. The casing and the front cover of the appliance become extremely
hot during operation. So do not touch the appliance during use: risk
of scald injury! Pay attention that no combustible materials (such as
curtains, marquees, flags, plastic foil etc.) due to wind or other
environmental influences come to close to the appliance. That can
cause singe damage or fire. Pay attention that they don’t cover or
obstruct the appliance. That can cause damage or fire!
9. If the device has fallen or becomes damaged, or if the appliance, by
whatever which reason, produces cracks or breaks, if you during
the operation establish imperfection or interruption, or if the
aluminium casing, the front cover surface or the cord or plug show
flaws, discontinue the operation of the appliance and take the plug
from the socket.
10. If the appliance, the cord or the plug is damaged or shows
imperfection, contact your supplier, the manufacturer or a qualified
