EN
BEFORE USING YOUR PUMP…
Read this entire instruction leaflet carefully. It contains important information in relation to the
use of your pump and precautionary measures that may need to be taken. Reading these
instructions thoroughly will ensure you get the very best performance from the product and
ensure maximum safety. Any use, other than set out in this leaflet, could cause damage, injury
and represent a hazard; it will also invalidate the guarantee.
Keep this booklet in a safe place for reference.
SAFETY RECOMMENDATIONS
Before using your new pump, check it, including cord and plug, for any visible damage. Do
not use a damaged pump, but send it back to your dealer for replacement.
For safety reasons, your submersible pump must always be connected to an earthed socket
that has been installed according to national regulations, forms part of an electricity network
that is equipped with a fuse of at most 16 Amp and has an earth leakage circuit breaker
(nominal voltage ≤30 mA).
Check your pump, electrical cable, plug and socket before each use. Do not use if the
device is damaged and have this damage repaired by an accredited electrician. The cable is
an H05RN-F 3G 1.00mm² type.
Ensure that electrical connections stay dry at all times. Do not touch them with wet hands.
Before use, ensure that the socket to which you are connecting the pump is suitable for the
pump itself (see type plate).
Protect the electrical cable and plug from heat, oil and sharp corners.
Clean the drainage pipe before use.
Before use, check to ensure that elevation height does not exceed your pump’s capacity.
Do not use the electrical cable to hang up, lower or move the pump. Attach a rope to the
handle in order to do this. Never pull on the cable to remove the plug from the socket but
remove by pulling on the plug!
Rinse the pump with clean water if you have used it to pump water that contains chlorine, for
example, or deposits. Bear in mind that sand and all other abrasive and corrosive
substances will increase wear and tear and impact upon the effectiveness of the pump.
Ensure the pump is not used if it cannot drain off the water due to issues such as blocked
drainage, elevation too high, etc. This will damage the pump!
Do not use the pump if there are persons present in the object to be pumped out. It is
forbidden to use this pump in a swimming pool.
Allowing the pump to run dry will increase wear and tear and cause overheating. Always
prevent the pump from running if no water is being moved and switch it off immediately if this
is the case.
Before you carry out checking or cleaning tasks on the pump you must switch it off by
removing the plug from the socket.
In order to prevent injury, never put your fingers into the suction opening on the pump when
the device is plugged in!
Close supervision is necessary when the product is used near children, incapacitated
persons or pets. The device is not suitable for use by persons (including children) with a
physical, sensual or mental limitation or a lack of experience and knowledge, irrespective of
