31
Secure both screws and thereby clamp the panel in the feet.
Your E-convect LCD in control is ready to use.
Use and working
Make sure the heater is not damaged.
Insert the plug in the socket
Turn the switch (6) on (I): the light will turn on and the display flashes fleetingly
on the last set temperature and then displays the room temperature.
If you press the up/down key (7&8), the temperature setting will flash 5x on the
display. You can adjust the temperature setting by pressing the up/down key
while it is flashing. With each key press, the temperature will be increased (▲)
or decreased (▼) by one degree. If you set the temperature higher than the room
temperature, the heater will operate until the set temperature is reached.
The device will retain the temperature setting by switching itself on and off
automatically.
To switch the E-convect LCD in control off, you turn the switch off (O); the light
and the display goes out. Remove the plug from the socket.
Remote Control
The E-Convect LCD in control can also be operated with the included remote
control. It also includes a timer function.
Push the plug in the wall socket.
Switch the switch (6) on (I): the light comes on and the
display flashes fleetingly on the last set temperature and
then indicates the room temperature. You can now use
the remote control.
To set the temperature, press on the ‘heating’ button.
The – (down) and + (up) buttons now work as the ▼
and ▲ keys on the device.
To set the timer, (while the device is working) press on
the ‘Timer’ key, then you set the hours with the + and
– buttons (max. 24): the display fleetingly shows the set
number of hours and will repeat this intermittently. The
heater switches itself off after the selected number of
hours.
You can set the device on standby at any stage by using the ‘power’ button: the
display switches off, the switch globe continues burning. You can now also switch
on the device with the power button.
To switch off the E-convect LCD in control, switch off the (O) switch; the globe
and the display switches off. Remove the plug from the power point.
