33
Installation and preparation
Do not start using the air cooler until:
- all packaging is removed and placed away from children.
- all safety instructions have been observed.
- the air cooler or the plug is NOT plugged into the socket.
Turn the lock button (9) open and pull the water reservoir roughly 20 cm
backwards and fill with clean cold water; Fill the reservoir above the "MIN"- but
below the "MAX" level. Ensure that the plug does not get wet or fall into the
water tank. Never use the cooling or the humidifying function without sufficient
water in the water tank.
If you require extra cooling, you could add frozen ice packs or ice cubes in the
water reservoir (not included).
If you wish to use the cool of humidifying function, ensure there is sufficient
water in the reservoir.
If you have not used the unit for some time, refresh any remaining water.
Put the air cooler in the correct position.
Insert the supplied battery into the remote control. The remote control operates
on a button cell battery CR2025 (3V).
Always unplug the power cord when you pour water in or out of the tank!
Operation
Insert the plug into a wall socket. The device will switch on in stand-by
position. The device is now ready for use. Check that the vertical blinds are
open at the front Press the button and the fan will start blowing at the
Medium fan speed. By pressing the button again, the device will return to
the stand-by position.
Select the required mode on the control panel or the remote control.
The control panel and the remote control have similar functions.