45
Safety
The Coolperfect 90 / Coolperfect 120 / Coolperfect 180 are fitted with an overheating
safeguard that switches the unit off if it overheats. If this should occur, you must
remove the plug from the socket and leave the equipment to cool for at least 30
minutes. Remove the cause of overheating - has the device been (partially) covered?
Is it too close to a wall or another obstacle, preventing it sucking in or dispelling
sufficient air?
You can then use the device normally again but keep an eye on it for the first 30
minutes to ensure there are no further problems. If the device is showing signs of
problems or the overheating recurs, even though there is no obvious assignable
cause, ask your supplier or a recognised electrician to check/repair the unit.
Cleaning and maintenance
Note! Before cleaning or carrying out maintenance work on the air conditioning unit,
always switch off and remove the plug from the socket! Regular cleaning is vital in
order to keep the unit in good working order!
Cleaning the housing
Use a soft, damp cloth to wipe the housing.
Never use aggressive cleaning products, petrol, detergent, chemically-impregnated
cloths or other cleaning solutions. These could damage the housing. Never spray the
unit and ensure that water never penetrates the device! Dry the unit with a soft cloth.
Cleaning the filter
Clean the filter once every two weeks; a unit with a dirty filter will never work
properly. The filter can be found behind
the air inlet grilles on the side. You can
easily open these grilles and remove
the filter. Use a vacuum cleaner or
gently beat the filter to remove loose
dust and dirt. Rinse the filter with tepid
water (not hotter than 40°C) with a
mild, neutral cleaning product. Let the
filter dry thoroughly in the shade
before replacing in the unit. Take care!
Never use the air conditioning unit
without the filter!
Cleaning of radiator
Clean the radiator behind the filter carefully with, potentially, the brush of the
vacuum cleaner.
End of season cleaning
If the device is to be stored for a long period, you must take the following measures!
Open the water drain and completely remove the condensed water. Let the unit
run for several hours, so that the air conditioning is dry on the inside.
Then switch the air conditioning unit off and remove the plug from the socket.
Clean the filter and reposition them or replace with a new one.
Unscrew the waste pipe from the device in order to prevent damage.
Pack the air conditioning unit in its original packaging or in a plastic bag and place
in a dry place for storage. Place a heavy object on the unit.
