Memory
The Cool perfect has a memory. If the electricity supply is disrupted and then resumed it will
return to operation in the last mode. If you have switched the device off with the Power button
(as recommended) and then removed the plug from the socket, it will return to the stand-by
setting when you re-connect the power supply. You must then select the desired function again.
Via remote control:
The remote control provides the same options as the buttons 1-8 on the control panel.
Via an app (Cool Perfect 150WIFI)
The perfect Cool 150WIFI can, via Wi-Fi, also be operated by an app. See the separate app
instruction.
When you start the Cool Perfect and select a certain function or change the function, the fan will
start up but the compressor will not begin to work immediately; this is to protect the internal
components. The symbol that corresponds to the display (see diagram) will blink to show it is
‘waiting’. This can take 3 to 4 minutes.
The horizontal fins for the outlet opening can be adjusted manually to change the outlet
direction.
If the cooling function is used for a while, internal ice may form in the Cool Perfect. You will
notice a drop in the unit’s effectiveness as a result. To resolve this situation, switch the unit off
and leave for a while so that the ice can melt. The fan can also be switched on at the highest
setting without cooling.
When the desired cooling or heating temperature has been reached the Cool Perfect will
continue to ventilate, but the compressor will stop.
MAINTENANCE
Always switch the unit off and remove the plug from the socket before carrying out maintenance.
Regular cleaning is vital in order to keep the Cool Perfect in good working order!
The air filters are located behind the grills on the sides of the device. They can be taken out
easily by pulling them forward and then removing them. You clean them by carefully using the
brush attachment on your vacuum cleaner. If they are extremely dirty you may wash them with
diluted soapy water. Allow them to dry thoroughly in the shadow before re-installing them. Never
use the device without filters!
The radiators behind the filters can be carefully cleaned with the brush attachment of your
vacuum cleaner.
The housing can be removed if necessary and cleaned with a damp (not wet!) cloth and a mild
cleaning agent. Do not use paraffin or chemical cleaning agents! Dry afterwards with a soft cloth.
Storage Ensure that the interior of the device is also completely dry before you tidy up at the end
of the season.
PROTECTION
The Cool Perfect is fitted with an overheating safeguard that switches the unit off if it overheats. If
this should occur, you must remove the plug from the socket and leave to Cool Perfect to cool for
at least 30 minutes. Remove the cause of overheating - has the device been (partially) covered?
Is it too close to a wall or another obstacle, preventing it sucking in or dispelling sufficient air?
You can then use the device normally again but keep an eye on it for the first 30 minutes to
ensure there are no further problems. If the device is showing signs of problems or the
overheating recurs, even though there is no obvious assignable cause, ask your supplier or a
recognised electrician to check/repair the unit.
