Press this button during heating and the set temperature will be decreased by one degree after
an hour and by a further degree after a second hour. This setting will be maintained; the fan
works on a low speed.
The sleep function cannot be used during dehumidification.
4. Speed
Select fan speed with this button: low, medium or high. The corresponding light comes on.
Note: the speed button does not work during the dehumidifying process; the correct setting is
selected automatically (low).
5. Swing
When you press this button the slats on the outlet opening swing continuously to the left and
right. Pressing the button again switches the function off and the slats remain in their current
position.
6. Temp + = Temp. regulation up
During cooling: every time you press this button, the set temperature will increase by one
degree up to a maximum of 31°. During heating: every time you press this button, the set
temperature will increase by one degree up to a maximum of 31°.
7. Timer
Use this button to control the automatic activation and deactivation of the Cool Perfect.
Switching on: The device activates automatically when the set time has expired.
Activate the device with the function and at the temperature that you desire.
Switch the device off with the ‘power’ button.
Press the ‘timer’ button.
Set the number of hours (max. 24) with the ‘temp+' or ‘temp-' button and press another time
the ‘timer’ button.
The device will start automatically after this number of hours.
Switching off: When the set time has elapsed the device will switch off automatically.
Press the ‘timer’ button while the device is activated.
Set the number of hours (max. 24) with the ‘temp+” or ‘temp-‘ button.
The device will switch off automatically when this number of hours has elapsed.
If you press the ‘POWER’ button before the set time has elapsed you switch the device either
on or off and the timer setting is deleted.
8. Mode = Function selection
Press once or more on this button to select a function: cool, dehumidify, fan or heat. The
corresponding indicator on the control panel lights.
If you wish to heat you must first change the hose connections. See ‘Heating’!
If you wish to dehumidify, first connect the water outlet (see page 15).
Alarm
When the tank is full, the Cool Perfect stops. The WF-indicator starts burning and after 5
minutes the display shows ‘E2’. Switch the Cool Perfect off, remove the plug from the socket
and remove button A and cap B on the water outlet underneath the unit to drain water. Replace
button A and cap B and you can start the Cool Perfect as usual.
LED-display
The display shows whether power is connected and the temperature or timer settings. If
settings are amended, the display will show the new setting and then revert back to displaying
the set temperature.
The display also shows error codes, see later in the leaflet.
