Cooling:
Attach the flexible hose before you start
using the device:
Rotating the hose in the direction of
arrow 1 fastens it to the device. You
unfasten it by rotating in the direction of
arrow 2.
Rotate connection B onto the other end
of the hose.
and place it with the oval opening in the
opening in the window panel.
Avoid kinks or bends in the hose and
keep it sloping slightly upwards. Kinks
and bends will lead to a build up of
damp, waste air which can cause
overheating or lead to the Cool
Perfectair switching off. Keep the hose
as short as possible.
Heatling:
Attach the flexible hose to the hose
connection heating (D) and place it on
the adjustable fins (3).
Attach the round fan blade (E) over the
circular opening (8), see image.
Place the other end of the flexible hose
(with the oval opening) in the opening in
the window kit.
Please note: this device is primarily a
cooler. He can heat when the ambient
temperature is not lower than 16 ° C,
otherwise it will freeze inside after some
time.
Deshumidification:
To dehumidify you must connect a water
drainage hose. To do this, remove button
A and cap B and connect an appropriate
hose to drainage point C with a hose
clamp.
Lead the hose to a receiving container or
drain, ensuring that the hose does not
run upwards at any point.
further installation is necessary, even no
flexible outlet pipe.
Warning! Do not use your Cool Perfect until it has been installed according to the instructions
above!
