55
- One-off or repeated
- Anticipation on or off
- Thermostat setting
- Timer on-time
- Timer off-time
- Next timer setting
If you would like to delete a specific setting, press and hold WEEK and then
search for the timer setting that you need. Go past 01- ][ and on/off first by
pressing SET briefly. When the number of the timer setting that you wish to
change appears, press SET for a little longer. You will hear a short beep and the
selected setting has been deleted.
If you wish to delete all timer settings, press the WEEK button and hold. Press
and hold the MOD and SET buttons at the same time, until you hear a beep. The
screen will show 88:88, indicating that all settings have been deleted.
Please Note: all timer settings can only be deleted with the buttons on the
operating panel, not with the remote control!
If you wish to retain the timer details but do not want to use the timer for a
while, push and hold the WEEK button and then push and hold the MOD until
TIME disappears from the screen to indicate that the data will be retained but
will not be active. By pressing MOD again until TIME appears, you will reactivate
the timer.
Screen protection: If the settings on a working heater are not adjusted for 2
minutes, the LED display will go out but ON will stay on. It will light up again when
you press a button. If the heather is switched off using the ON/OFF button, the OFF
screen will stay on.
Using with the remote control:
The remote control (5) has the same 6 buttons as the operating panel
(MOD = MODE) and works in roughly the same way, but:
You cannot use the remote control (under M-mode) to set
the capacity with the + or - buttons. Use the bar button
for this purpose. Note: Does not apply to Alutherm
400XS, this model only has 1 heating level (400W full
power).
The remote control has an frostprotection button; the
heater maintains the room at 5°C. The screen shows FP.
Deactivate by pressing again. Nothing else can be set
under this setting.
If the heater is working on frostprotection setting and a timer setting
becomes active, the heater will start to work according to the timer
setting. When the heat goes off, the heater will not return to the
frostprotection setting, but go off.
