the channels.
The short sides of the other 2 brackets will fall against the wall. Mark where these
must be screwed to the wall and lift the heater out of the brackets.
Drill 2 holes at the marked locations and insert plugs.
Hang the heater back on the brackets, let it drop into the channels and screw the
last 2 large screws through the lower brackets against the wall.
Check to ensure your heater is horizontal and secure, with the minimum distance
to the floor, ceiling and any side walls.
Using for the first time and Operation
Check to make sure the main switch is set to O (off).
Check that the heater is stable and upright, in line with instructions.
Now insert the plug into the 220/240V socket.
Set the main switch to I (on). The display will show: OFF
Using the operating panel
The operating panel (3) has 6 buttons: MOD / SET / WEEK / + / - / and the ON/OFF
button
Press the ON/OFF button in order to switch the heater on. The display lights up
and the heater can be operated.
Now, set the day and time. Press and hold SET until SET appears on the screen.
The numbers of the weekdays (line 4) will blink. Use the + and – buttons to find
the right day (1 – Monday, 2 = Tuesday, etc.) and confirm with SET. The hour will
now blink. Use the + and – buttons to set the right hour and confirm with SET. The
minutes will now blink. Use the + and – buttons to set the right minutes and
confirm with SET. The day and time are now set.
Please Note:
o The day and time settings will be lost if the heater is switched off using the
main switch or plug; these will be retained if the ON/OFF button is used.
o If you do not set a time and day, the heater will assume that it is day 1 and
00.00.
o The screen goes off automatically after 2 minutes and can be turned on again
with any button.
Press MOD to set whether you wish to work with the M or P function.
Under the M-function, you use the + and – buttons (remote control: with the bar
button) to set the capacity at which the heater will work: low, medium or high - see
technical details. The thermostat cannot be adjusted.
Under the P-function, you can use the + and – buttons to set the desired
temperature for the heater, which it will then try to maintain. The heater will
automatically select the correct capacity: 1 or 2 degrees of heat = low, 3, 4 or 5
degrees of heat is medium and 6 or more degrees of heat is high. Once the
desired temperature is reached, the heater automatically turns off, and then back
on again when it cools down.
Under the P-function, you can also set the weekly timer. Pressing WEEK, allows
you to set or check the weekly timer. Please note! To set the weekly timer, you
must first enter the day and time correctly.
