512570
5
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
INSTALLATION/ASSEMBLY
-
The weather station is only to be placed and used in dry, enclosed indoor rooms.
Place it on a fl at, stable, suffi ciently large surface. Protect valuable furniture
surfaces by using an appropriate underlay, otherwise it may cause scratches.
-
The outdoor sensor is intended for installation in a protected outdoor area; hang
it on a screw or nail.
You should protect the outside sensor from direct precipitation; otherwise the
air temperature cannot be measured. Never use the outside sensor in or under
water; this will damage it!
REPLACING THE BATTERIES
a) Outdoor sensor
The display contrast decreases when the batteries run low. Furthermore, the battery
symbol “
” is shown in the display of the outside sensor and the weather station.
Replace the batteries with new ones. If the weather station cannot detect the out-
side sensor, press the “CHANNEL” button for approx. 3 seconds until the “ ” for
sensor search starts to fl ash. This process lasts approx. 3 minutes. During this time,
do not move the outside sensor nor the weather station, do not press any buttons.
b) Weather station
The display contrast decreases or the displayed symbols disappear when activating
the light, when the batteries run low.
Replace the batteries with new ones. All settings and data will be lost.
SELECTING TIME/DATE, TIME ZONE, 12/24 MODE
AND DISPLAY LANGUAGE

If the time or date are changed, the DCF reception is automatically switched
off.
-
Hold the “SET” button pressed for about 3 seconds until the year display fl ashes.
-
Using the “UP” or “DOWN” button, you can set the year.

If the respective key is pressed for a longer period of time, quick adjustment
is performed. This also applies to setting the month, date, hours and minutes.
If you do not press any key for 10 seconds, the weather station saves all set-
tings and exits the settings mode automatically.
-
Briefl y press the “SET“ button and the month fl ashes. Using the “UP” or “DOWN”
button, you can set the month.
-
Briefl y press the “SET“ button and the date fl ashes. Using the “UP” or “DOWN”
button, you can set the date.
-
Briefl y press the “SET“ button and the time zone fl ashes. Using the “UP” or
“DOWN” button, you can set the time zone from +12 to -12 hours.
-
Press the “SET” button several times and the “24h” or “12h” fl ashes on the dis-
play. Using the “UP” or “DOWN” button you can choose either the 12h or the 24h
mode. In the 12h mode, “am” is displayed for before noon and “pm” for after noon.
-
Briefl y press the “SET“ button and the hour display fl ashes. Using the “UP” or
“DOWN” button, you can set the minutes.
-
Briefl y press the “SET“ button and the minute display fl ashes. Using the “UP” or
“DOWN” button, you can set the minutes.
-
Briefl y press the “SET” button and the language for displaying the day of the
week fl ashes. Set the language using the “UP” or “DOWN” button (“GER” = Ger-
man, “ENG” = English, “FRA” = French, “SPA” = Spanish, “ITA” = Italian, “DUT” =
Dutch, “DAN” = Danish).
-
Briefl y press the “SET” button again to exit the settings mode. All settings will be
saved.
MANUAL START OF THE DCF RECEPTION
Press the “DOWN °C/°F WAVE” button for approx. 3 seconds in order to start the
DCF reception attempt manually. The radio tower symbol “
” will fl ash.
The reception attempt lasts for approx. 3 - 7 minutes, do not move the weather sta-
tion during this time, do not press any button.
If the current time of the day and the date are still not displayed after this period,
choose another location for the weather station and perform the reception attempt
again.

Do not place the weather station next to electronic devices, metal parts,
cables and so on. Bad reception can also be expected with metallised in-
sulating glass windows, reinforced concrete constructions, coated special
wallpaper or in cellar rooms.
MANUAL START OF THE OUTDOOR SENSOR RECEPTION
Press the “CHANNEL” button for approx. 3 seconds until the symbol “ ” for sensor
search starts to fl ash. This process lasts approx. 3 minutes. During this time, do not
move the outside sensor nor the weather station, do not press any buttons.
TOGGLING THE TEMPERATURE UNITS °C/°F
Briefl y press the button “°C/°F” on the weather station in order to toggle between
°C (degree Celsius) and °F (degree Fahrenheit).
If the temperature reading the the display of the outdoor sensor is to be changed,
open the battery case of the outdoor sensor and briefl y press the “°C/°F” button
located there.
ALARM FUNCTION
c) Switching the alarm function on/off
-
-
Briefl y press the “ALM-SET“ button to switch the alarm function on or off.
-
If the alarm function is activated, a small bell symbol “ ” appears on the left
above the time.
b) Setting the alarm
-
-
Press the “ALM-SET” button for about 3 seconds and the hours of the alarm time
will start fl ashing.
-
-
Using the “UP” or “DOWN” button, you can set the hours of the alarm time.
-
-
Briefl y press the “ALM-SET“ button and the minutes of the alarm time fl ash.
-
-
Using the “UP” or “DOWN” button, you can set the minutes of the alarm time.
-
-
Briefl y press the “ALM-SET” button to exit the settings mode.
c) Snooze function
There is a button inbuilt on each of the device’s front feet.
When the alarm signal sounds, simply press the top of the housing to activate the
snooze function. The bell symbol “
” fl ashes.
The alarm signal is interrupted for approx. 5 minutes after which it starts again.
d) Stopping the alarm signal
When the signal is sounded at the set alarm time, it can be stopped by pressing any
button on the back of the weather station.
If no button is pressed, the alarm signal stops automatically after 2 minutes.
DELETING MAX/MIN VALUES
-
-
Briefl y press the “MEM” button in order to toggle between the maximum values
(the display shows “MAX”), the minimum values (“MIN”) and the current meas-
ured values.
-
-
To delete the saved maximum and minimum values, hold the “MEM” button
pressed for at least 3 seconds.
SELECTING THE SENSOR CHANNELS
Briefl y press the “CHANNEL” button, to toggle between the three outdoor sensors
for outside temperature.

The respective channel number is displayed on the left of the displayed
measured values of the outdoor sensor.
ACTIVATING THE DISPLAY LIGHT
There is a button inbuilt on each of the device’s front feet.
To activate the display light, press the top of the housing briefl y. The light automati-
cally goes out after several seconds.
WEATHER FORECAST
The weather forecast for the next 24 hours is calculated based on measurements of
trends in the barometric pressure. This results in an accuracy of up to 70%.
The weather forecast is indicated by a graphic symbol in the display.
Please note:
-
If “Sunny” is displayed at night, this means a clear night with clearly visible stars.
-
The display does not represent the momentary weather situation, but is a forecast
for the next 12 to 24 hours.
-
The calculation of the weather forecast based only on barometric pressure results
in a maximum accuracy of about 70%. The actual weather the next day can there-
fore be completely different. Since the measured barometric pressure only applies
for an area with a diameter of about 50 km, the weather can also change quickly.
This is especially the case in mountainous areas and high mountain regions.
Therefore, don‘t depend on the weather forecast of the weather station, but in-
form yourself locally when you would like to hike in the mountains, for example.
-
In case of sudden or larger air pressure fl uctuations, the display symbols are up-
dated to indicate the weather change. If the display symbols do not change, either
the air pressure did not change or the change occurred so gradually that it cannot
be registered by the weather station.
-
If the weather forecast shows “Sun” or “Rain”, the display will not change even if
the weather improves (display “Sun”) or deteriorates (display “Rain”) since those
symbols already display the two extreme conditions.
The symbols indicate a weather change for the better or worse, which does not
have to mean sun or rain, however, as indicated by the symbols.
-
After inserting new batteries, you should not pay attention to the measuring val-
ues and weather forecasts for the fi rst 12 to 24 hours, because the station must
rst collect air pressure data in this period at a constant height above sea level
before being able to make a more exact forecast.
-
If the weather station is brought to a signifi cantly higher or lower location than
the original site (e.g. from the ground fl oor to the upper storeys of a building) the
weather station may possibly erroneously detect a change in weather.
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Eurochron EFWS 801 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Eurochron EFWS 801 in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 0,51 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info