807232
8
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
8
Personal injury or property damages caused by protruding parts.
Parts protruding beyond the edge of the vehicle or rack may cause personal
injury or property damage during the journey.
Only mount parts that do not protrude beyond the edge of the vehicle.
Personal injury or property damage possible due to a damaged
bicycle rack.
Damage to the rack, e.g. by bent parts, cracks or scratches, prevents the safe
operation of the rack.
Property damage caused by hot exhaust gases.
Damages may be caused to the rack or bicycles if the exhaust outlet is close
by.
Use an exhaust de ector if necessary.
Property damage due to opening tailgate.
The tailgate could hit the bicycle rack and be damaged.
Switch o the electric tailgate and operate it manually.
Do not mount the bicycle rack if it is damaged in any way.
Follow the steps as described in the chapter on „Maintenance”.
Personal injury or property damage possible due to loss of bicycle
parts while driving.
Personal injury or property damage due to loss of the bicycle rack
while driving.
Damaged may be caused by parts that can be lost if they come away from
the bicycle during the journey.
Remove all parts that may be lost before starting your journey, these
include air pumps, battery-powered lamps, navigation systems, bicycle
computer, tool bags or baskets.
A loose or faulty connection between the bicycle rack and trailer tow bar
can lead to the detachment of the bicycle rack.
Replace a defective trailer tow bar.
Clean the trailer tow bar of dirt, dust and grease.
Personal injury or property damage due to overloading.
Exceeding the maximum payload of the bicycle rack and the permitted
supporting load of the trailer tow bar or permitted overall weight may lead
to serious accidents.
Always observe the speci cations regarding the maximum payload,
permitted supporting load and permitted overall weight of your vehicle.
Do not exceed these speci cations at any time.
Personal injury or property damages caused by increase wind
loads.
The bicycle rack and trailer tow bar may be damaged by too high a wind
load
Remove all bags from the bicycle before starting your journey.
Do not use protective covers for the bicycle during the journey.
The general operating permit must be carried in the
vehicle when the rack is mounted.
Do not travel with the bicycle rack empty. Store it in
the boot of your vehicle. This prevents increased fuel
consumption and protects the rack.
The driver is always responsible for ensuring that the
load and the load securing meet the regulations.
Rack table, left half
Rack table traverse
Lock screw M6 x 70
Washer 6 mm
Nut M6
Rack table, right half
5.1.1 MOUNTING THE USHAPED BRACKET
Place the left and right halves of the rack table on an even surface with the
wheel rail openings facing upwards. Secure the rack traverse to the rack
table by feeding the M6 x 70 lock screws from the top through the table and
traverse and screwing into from below with washers and nuts. At this point,
do not yet tighten the nuts. Pay attention to ensure that the screws for the
license holder are on the outside of the rack traverse.
5. OPERATING INSTRUCTIONS
5.1 MOUNTING THE BICYCLE RACK
The bicycle rack must  rst be assembled. Take all of the components out of
the packaging and set them out clearly. Check the scope of delivery. Every
stage is described and clearly shows which components are required for the
assembly of the rack.
Connection
Connect both rack halves with the connection plates and the table. Make
sure that the large, central drilled hole of the connection plate lines up with
the hole of the rack table. Insert the four M8 x 50 hexagonal screws with
washers, from the inside, through the connecting plate and the square
pipe of the rack table. From the outside, place the rack base on the ends of
the screws. In doing so, the mount for the tow bar must be at the bottom.
Secure the base using washers, spring washers and nuts. Now screw the
RESULT
Hexagonal screw
M16 x 90
Hexagonal screw
M8 x 50
Washer 8 mm Nut M8 Spring washers 8 mm
Connection plates
Base
Bottom
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Eufab 11411 - Bike Two bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Eufab 11411 - Bike Two in de taal/talen: Duits, Engels, Frans, Italiaans als bijlage per email.

De handleiding is 1.25 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info