33
32
FAULTS
PROTECTIVE EQUIPMENT
Ventilation protection
The electronics in the appliance must be
cooled. The cool air is drawn in at the front
and blown out at the rear. The appliance can
therefore only function when sufficient air can
circulate. If insufficient air is able to circulate,
the appliance will switch off after a short time.
Overheating protection
The appliance may become overheated if:
– the pan does not conduct the heat
adequately;
– fat or oil is heated at a high setting;
– there is insufficient circulation of air (see
also ventilation protection).
In the event of overheating the result will be
that the cooking zone in question or all the
cooking zones will display one of the following
reactions:
– the turboer function is switched off (if
already switched on);
– if setting 9 has been selected, a 9 and an 8
will flash in the display(s) in succession.
The power level is lowered to setting 8;
– The cooking zone(s) in question is/are
automatically switched off. First a 0 and
then the residual heat indication will
appear in the display in question.
As soon as the cooking zone(s) has/have
cooled down sufficiently, they can be
operated normally once again.
Prevent the overheating protection becoming
activated by:
– using pans that are good conductors of
heat;
– heating up fat or oil at a lower setting;
– making sure there is sufficient ventilation.
If, despite the above-mentioned measures
having been taken, the overheating
protection becomes activated again,
contact the service department or a
professionally qualified specialist.
Faults
Please check the following points which may solve the problem, before calling the service
department. Try to deal with the problem yourself first by checking the table below. For
addresses and telephone numbers of the service department, please refer to the enclosed
guarantee card. If the message "E", followed by a two-digit code or the message “F”, appears in
the display, you should contact the service department and mention this code.
Sympton
The appliance does not work.
The lights do not light up.
The cooking process stops
and the displays start to flash.
appears in the display after
the appliance is switched on.
Cause
No power supply.
Overheating protection comes
into operation.
A cooking zone with no pan on it
is switched on by accident.
Unsuitable pans.
Poor electrical connection.
Action
Check the electrical installation
(main fuse(s), connection of the
hob).
Check ventilator openings.
Place a pan on the cooking zone.
Use suitable pan.
Check if the cable is being
caught by the drawer. If it is,
have it changed by the installer.
