807497
55
Verklein
Vergroot
Pagina terug
1/76
Pagina verder
ENDURO® EM515FL 45
Ref: EM515FL-UM-TKI-0323-Rev.B.
After manoeuvring, deactivate the manoeuvring system by moving the slide switch of the remote handset (Fig.
8A) down (Position “0”). The communication icons on the remote handset will turn off. Store remote handset in
a safe place (out of reach of children or other unauthorised people).
Turn off the battery power isolation switch.
Before you start driving always make sure that the both drive units are fully disengaged!
OPERATION FINDING LEVEL
It is possible to completely level the caravan with the manoeuvring system and autoSteady system.
First of all, it is important that the caravan is skewed within the set specifications:
Make sure that the caravan tilts a few degrees forward, possibly turning the nose wheel slightly in.
Make sure that the caravan on the axle does not tilt too much to one side. The maximum height difference
between the left and right wheel may not exceed 10cm (for a caravan with a width of 230cm).
When activating the “finding level function” but having the caravan tilting too much to one side (on the axle),
the remote handset will give an optical signal and the leveling system (Fig. 8O) will indicate which side of the
caravan is too low. The Finding Level function will not start and also the Finding Level icon (Fig. 8S) will not
light up.
If the caravan is almost in place, press the FL button (Fig. 8T) on the remote handset during at least three
seconds (every second there will be a beep). If the caravan is misaligned within the specified specifications, the
Finding Level icon (Fig. 8S) will light up continuously. The system is ready to continue.
Place the wedge / leveler (not supplied) on the front or on the back of the wheel which is lowest (Fig. 15, 16).
Now you can choose the movements according the symbols shown on the remote handset. Straight forward
(Fig. 13B) or straight reverse (Fig. 13C) or possibly left forward (Fig. 13D), left reverse (Fig. 13F), right forward
(Fig. 13E), right reverse (Fig. 13G).
As soon as the caravan is level in the width direction (on the axle (Fig. 17)), the manoeuvring system will stop
automatically and the remote handset will give a buzzer.
NOTE: The Finding Level system only stops if the caravan is level in the width direction (on
the axle). If the ramp/leveler used is not high enough, or if a different situation arises, the
caravan may run over the ramp/leveler. Make sure you release the remote control buttons
in time!
If the manoeuvring system is extended with the autoSteady system, then the corner steadies will also be
automatically turned out (Fig. 18) and the caravan will also be levelled automatically in the longitudinal
direction. However, it is very important that the caravan tilts a few degrees (front of caravan a little down),
otherwise the system will stop and the remote handset will give an optical message and the waterlevel display
will blink.
If this situation occurs, turn the nose wheel slightly in and again go through the Finding Level process (press
the FL button). Since the caravan is already level at the axle, and thus the corner steadies will turn out.
If the caravan is tilted for a few degrees, the front corner steadies will be automatically turned out, and the
caravan will be leveled in the longitudinal direction. Then the rear corner steadies will be turned out. Finally, all
corner steadies will shortly be turned out (short boost) to stabilize the caravan.
As soon as the caravan is level and stable, the remote control will give a buzzer (2 beeps) and the Finding Level
icon will go off.
When you are ready with manoeuvring you need to secure the handbrake.
If necessary, place a "counter- keg/leveller" behind the wheel on the keg/leveller to prevent rollback (Fig. 19).
Press at the same time, during at least three seconds, the two buttons for disengaging the motor powered
rollers (Fig. 8J). The disengaging icon (Fig. 8P) will blink fast during these three seconds and every second
there will be a beep. This warns you that the system will be activated!
After these three seconds the motor powered rollers will be released from the tyre and the disengaging icon will
illuminate constant, now you can release the two buttons. When the motor powered rollers are completely
disengaged you hear a short beep, the disengaging icon will switch off and the system is ready for transport.
After manoeuvring, deactivate the manoeuvring system by moving the slide switch of the remote handset (Fig.
8A) down (Position “0”). The remote handset screen will turn off. Store remote handset in a safe place (out of
reach of children or other unauthorised people).
55

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Enduro EM515FL bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Enduro EM515FL in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 38.02 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info