Handleiding Elta BA123 (pagina 21 van 177) (Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools, Turks)

641710

Verklein

Vergroot

Pagina terug

1/177

Pagina verder

If you press the ZEIT (Time increase) (16) - until the display reads 8:10 then the loaf will be

ready in 8 hours and 10 minutes. You can press and hold the ZEIT (Time) (left/right) buttons to

scroll quickly to your desired setting. You can set a maximum of 13 hours.

• NOTES: Once you have pressed START/STOP (12) you cannot alter the timer. If you need to

reset the timer press START/STOP (12) button for 3 seconds and the machine will reset, after

which you can re-select your programme and timer accordingly.

Note: Do not do this if the process is past the first kneading. Do not use perishable ingredients like

milk or eggs when using the delay timer as these will spoil whilst sitting in the bread pan (2). You

cannot reduce the delayed time to less than the process time.

CLEANING AND CARE

• In addition to this, you must observe the safety instructions.

• Let the unit cool down completely before starting to clean it.

• If necessary, remove the baking mould (2) from the unit and remove the kneading hooks (3) from

the drive shafts (4). The baking mould (2) and the kneading hooks (3) have a non-stick coating.

This facilitates cleaning. The baking mould (2) and the kneading hooks (3) should be cleaned with

a mild cleaning solution and warm water.

• Never use any abrasive cleaning agents, scouring aids or scratching sponges. If the kneading

hooks (3) become encrusted or difficult to remove from the drive shafts (4), fill the baking mould

(3) with hot water. After about 30 minutes, try again. Dry the parts well before putting them back

into the unit.

• The baking mould (2) and the kneading hooks (3) should not be washed in the dishwasher.

• Do not place the baking mould into water. This might cause damage to the protection on the

bottom of the mould.

• Wipe the baking compartment and container using a moist cloth and let dry completely.

FREQUENTLY ASKED QUESTIONS

• Q: The motor did not run when I pressed START/STOP (12).

A: It's not supposed to. All the programmes start with a pre-heat step that ensures all the

ingredients are at the right temperature before the process starts.

• Q: The machine beeped part way through the process.

A: This is the signal to add optional ingredients like fruit or nuts. Some of the recipes call for

extra ingredients. Refer to the appropriate recipe for more information.

• Q: I tried to make another loaf right after the first but the process wouldn't start.

A: The machine must be allowed to cool thoroughly before another loaf can be made.

PROBLEMS

• Sunken loaves: Typically, what happens is the dough will rise very well then sinks just as the

baking process starts. Most of the time, this is because the dough was not strong enough. Whilst

the yeast is still producing gas a weak dough will maintain a good shape but once the yeast is

killed by the baking process, the loaf can sink under it's own weight. The mixture is too wet

causing weak dough.

⇒ Too much water/not enough flour. This will make the dough watery. The dough should be soft

but firm.

⇒ Some brands may need some adjustment to the ingredients. Some types of flour absorb less

water than others. In this case, add an extra 50 g of flour to make the dough thicker.

• The gas bubbles produced by the yeast are escaping! Dough without gluten is like water

without soap; you cannot make bubbles.

⇒ The white flour brand you are using probably does not have sufficient gluten to make a decent

dough.

• The yeast is dead or has gone off.

⇒ If you use warm water, the yeast may be exhausted before the rising process is complete.

Tap water is usually fine. Be extra careful that the yeast does not come into contact with the water

before the mixing process starts. This is particularly important when using the timer.

⇒ Check the “best before” date on the yeast sachet. If it is close to expiry it would be best to buy

another.

⇒ Avoid using yeast from sachets that are already opened. Use a new sachet every time.

• The loaf did not rise! Many of the reasons why bread doesn't rise are outlined above. But first, let

us eliminate the obvious:

⇒ Whole meal & brown loaves seldom rise as well as white.

⇒ You did put the yeast in didn't you? It's easy to forget.

⇒ A common error is mistaking teaspoons of salt for tablespoons. The yeast will not work well if

you add too much salt.

⇒ Both the flour and the yeast must be in good condition.

⇒ The mixture may have been too dry. Add 1 tablespoon of water to the mixture if necessary. If

you feel that the yeast should be increased then only add an extra 1 tsp – but not more.

• The loaf rose too high and stuck to the lid!

⇒ Usually caused by too much yeast, too much water or flour, or forgetting to add the salt. Salt

keeps the yeast in check - without it the yeast can cause the loaf to over-rise.

39 40

BA123-01-GE/EN 1/9/04 1:58 PM Page 21

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Elta BA123 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info