782457
38
Verklein
Vergroot
Pagina terug
1/144
Pagina verder
34
EN
14_ASSEMBLING THE SUITO-T
- Unpack the SUITO-T (A)
- Place the SUITO-T (A) in a vertical position and hold it in
place with the upper handle
- Unfold the right leg until the safety locking mechanism
clicks (Pic 1)
- Unfold the left leg until the safety locking mechanism clicks
(Pic 2)
- Make sure that the hometrainer is stable (Pic 3) or
alternatively adjust its feet (Pic 4).
15_INSTALLING THE SPROCKET CASSETTE
ON THE SUITO-T FOR Ø5 L=130 MM AND
L=135 MM CHAINSTAYS
- Assemble the sprocket cassette on the freehub by ali-
gning the groove profiles.
- 2 spacers (Ref. B) are usually needed for the Shimano®
/ SRAM® 9 speed cassette (Pic. 5), 1 spacer for the 10
speed cassette (Pic. 6) and no spacer is required for the 11
speed cassette (Pic. 7). Depending on the cassette brand
you are using there might be some differences with the
aforementioned general data.
- Using the torque wrench, tighten the lock ring supplied
with the cassettes onto the freehub body (Pic. 8).
CAUTION!
Strictly follow the instructions provided by the cassette ma-
nufacturer with regard to specific installation techniques,
the need for additional spacers and torque specifications.
NOTE: please contact your dealer if you have questions or
are unable to install the cassette. The warranty does not
cover any damage to the bicycle and/or SUITO-T in the
event of incorrect installation.
On bikes with 130-135 mm (5,1 -5,3 inch) chainstay you
must insert the right chainstay adapter (Ref. D) (Pic. 9) ) and
the left adapter (E) (Pic. 10). However, on bikes with ø12 mm
(ø 0.47 inches) thru-axle and 142 mm (5,6 inches) chainstay
please check paragraph 17.
16_INSTALLING THE BICYCLE ON SUITO-T
- Loosen the bike’s rear brake and place the chain on
the smallest rear sprocket and the largest front chainring.
Remove the quick release from the rear wheel.
- Remove the rear wheel from the bicycle.
- Insert the quick release and the dropout adapter (Ref. C) on
the SUITO-T sprocket cassette (Pic. 11A-11B).
- Place the bicycle chain onto the smallest sprocket of
SUITO-T (Pic 12).
- Fully fit the bicycle’s rear dropouts onto SUITO-T’s cassette
(Pic. 13), paying careful attention to the correct internal or
external position, based on the type of bicycle:
- External triangle adapter (Ref. C) for road and time trial bikes
(130mm triangle) (Pic.14).
- Internal triangle adapter (C) for mountain bikes (135mm
triangle) (Pic. 15).
NOTE: the knurled side of the triangle adapter (Ref. C) must
be facing the bicycle dropout.
- Securely fix the bicycle to SUITO-T and firmly close the
quick release. The resulting pressure should keep the bicycle
dropouts locked to the SUITO-T.
- Make sure the bike is perfectly vertical once installed.
WARNING: the dropout of the bicycle must be leaning on the
edges of the adapter and not on the Quick Release.
Elite shall not be liable for any damages that might arise from
an improper assembly of the bicycle on the hometrainer.
17_INSTALLING THE SUITO-T ON BICYCLES
WITH Ø12 L=142 MM CHAINSTAYS
1) Insert the left adapter (Ref. G) and screw the rigth adapter
(Ref F) for 142mm carriages (Fig. 16);
2) Loosen the rear brake of the bicycle and place the chain
on the smallest sprocket of the rear wheel and the front
chainring. Remove the thru-axle from the rear wheel.
3) Position the bicycle’s rear dropouts on the axle of the
sprocket cassette of the SUITO-T.
4) Insert the thru-axle on the SUITO-T sprocket cassette shaft.
5) Make sure the bicycle is safely positioned on the SUITO-T
and lock the thru-axle with a strong push. The pressure
should make the bike dropouts remain locked onto the
structure of the SUITO-T.
6) Make sure the bike is stable by pushing and pulling the
top tube of the frame and the saddle. Should the bike still
be moving a little on the SUITO-T, use more force to lock
the thru-axle.
7) If you wish for more bicycle stability it's advisable to use the
provided Riser block (Ref I) to be placed under the front wheel.
- Start pedalling. Ride very slowly at first and increase your
speed gradually until you become familiar with the features of
SUITO-T.
18_POWER SUPPLY
- SUITO-T feature electronic circuitry inside and is powered
up by a standard power supply (included).
Insert the power supply in the electrical outlet and the jack
plug in the connector on the back of the SUITO-T (Pic. 17),
a slight vibration indicates that the system is adjusting to its
initial position. This can last up to 15 seconds.
Place the cable inside its housing in the rear of the
hometrainer and hook it in the edges in the lower area of the
rear plastics (Pic. 18)
The SUITO-T compliance with EU laws (see “Declaration of
conformity”, page 115) may be voided if a charger different
from the original is used.
38

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Elite Suito-T bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Elite Suito-T in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools als bijlage per email.

De handleiding is 8.81 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Elite Suito-T

Elite Suito-T Installatiehandleiding - Alle talen - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info