-54-
Siren Tests
To test the external wireless siren:
x From the Service menu, select Test and then WL Siren Test [7031]; the wireless
siren is sounded briefly.
To test the built-in siren:
x From the Service menu, select Test and then Siren Test [7032]; the built-in siren is
sounded briefly.
Interface Test
The Interface test enables you to check if the speaker, LEDs and LCD are functioning
correctly.
To test the system interface:
x From the Service menu, select Test and then Interface Test [7033]; a short
sequence of chimes are sounded from the speaker, all LEDs flash and the LCD
is tested on all connected LCD keypads.
Walk Test
Walk Test mode enables you to test all the detectors registered to your system without
triggering an alarm.
To initiate Walk Test mode:
1. From the Service menu, select Test and then Walk Test [7034]; a list of
registered detectors appears.
2. Trigger each detector; when the system receives a successful transmission from
a detector, the detector is removed from the list.
3. When all the detectors are removed from the list, End Walk Test is displayed.
4. Press ̙ to exit Walk Test mode.
Snapshot Test
The Snapshot Test enables you to check if the PIR Camera detectors are functioning
correctly
To initiate the Snapshot Test:
1. From the Service menu, select Test and then Snapshot Test [7035]; a list of
registered PIR Camera detectors appears.
2. Select a detector from the list and press dž; a snapshot of the monitored area in
taken and the results can be viewed in the Web User Application.
3. Repeat the test for each installed detector.
4. Press ̙ to exit Snapshot Test mode.
