ENGLISH
When the programme has finished, the
(end)
pilot light comes on and the (Door) pilot light
goes off.
The (Door) pilot light indicates if during the
washing cycle the door can be opened:
• Light on: the door can be opened
(when the washing machine is set to PAUSE, the
(Door) pilot light will go off).
• Light off: the door cannot be opened
(when the washing machine is set to PAUSE, the
(Door) pilot light will start to flash)
The (end) pilot light flashes in the event of
operating problems and the corresponding alarm
code appears on the display.
E10 = the machine does not fill
E20 = the machine does not empty
E40 = the door has not been closed
To eliminate the problem, see paragraph “Something
not working”.
If the (filter clogged) pilot light flashes at the end
of the programme this means that the drain filter
must be cleaned.
13 Programme selector dial
The selector is divided into 5 sections:
• Cotton, linen
• Synthetics
• Delicates
• Woollens (hand washing)
• Special programmes
• Reset programme O
The selector dial can be turned either clockwise or
anticlockwise.
Position E corresponds to the ENERGY SAVING
programme and position to “cold wash”.
At the end of the programme the selector dial
must be turned to position O (reset).
14 Display
The display shows the following information:
Duration of the programme - Delayed start -
Incorrect option selection - Alarm code - End of
programme.
After selecting a programme, the duration is
displayed in hours and minutes ( for example 2.05).
The duration is calculated automatically on the basis of
the maximum recommended load for each type of fabric.
After the programme has started, the time remaining
is updated every minute
The selected delay (23 hours max) set by means of
the relevant button appears on the display for 3
seconds, then the duration of the previously selected
programme is displayed.
The countdown is updated every hour and when
remain the last 2 hours each 30 min.
Delayed start
Duration of the selected
programme
11
