632962
33
Verklein
Vergroot
Pagina terug
1/42
Pagina verder
Rascal R600 Scooter Owner’s Manual
EMC Part: 19271200 • Rev. 03 • 06/01/2003
28
Re-Assembly Notes: Slide the wheel onto axle, align key with slot in
axle. If snug, tap on wheel lightly with a rubber mallet. Replace the
hardware and tighten securely.
Front Wheel Removal Using the proper size wrenches on the nut and bolt, remove nut. Hold
wheel and slide the bolt out of fork, being careful not to lose any of the
wheel spacers.
Re-Assembly Notes: Align the wheel in the front fork and slide the bolt
through the fork and the wheel. Replace wheel spacers as required.
Tighten the nut and bolt securely with the proper size wrenches. Check
that the wheel spins freely. If not, loosen the nut (in quarter turn
increments) until the wheel spins freely.
Tire Tread Wear Measure tire tread depth. If less than 1/32", it is recommended you
replace the tire.
Seat Post Lubrication The seat should rotate freely. Clean and lubricate the top of the seat
post and the inside of the seat base attached to the seat. Lubricate with
petroleum jelly or other similar lubricant.
Caster Wheels If the caster wheels are badly worn; it is recommended that they be
replaced.
Clock Battery After time, the clock may begin to lose time, or stop, when the battery
runs down. The battery is easily replaced by removing the clock from the
dash, prying open the clock’s case, and inserting a new battery. Use the
following to replace the clock battery.
Battery Types: SR626SW, UCC 377, Ray-O-Vac RW329
1. Remove clock from the dash.
2. Use a small screwdriver to open the case by inserting the
screwdriver blade into the notch on the back cover. Gently twist
blade so that the back cover comes off.
3. Slide the metal battery cover plate aside and remove battery.
4. Install new battery with positive pole (+) facing outwards. Slide
battery cover back in place over new battery.
After replacing battery, make sure time setting is correct before
replacing clock into dash.
Electrical Connections Check battery terminals and all plug connectors to make sure that a
tight connection is made. If battery terminals are corroded, disconnect
the leads and clean all connections with a soft wire brush. Re-connect
leads and apply a protective coating (e.g., petroleum jelly, etc.) to
prevent corrosion.
33

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Electric Mobility Rascal 600C bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Electric Mobility Rascal 600C in de taal/talen: Engels als bijlage per email.

De handleiding is 6,37 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info