646322
28
Verklein
Vergroot
Pagina terug
1/46
Pagina verder
M
A
H
B C D E F
I
L
G
0
I
A
Commissioning
30
Prepare boiler for rst startup
Legend:
A On/o switch
B Return (ESC)
C Room temperature control
D Con rma on (OK)
E Manual mode
F Chimney sweeper mode
G Info mode
H Reset bu on
I Opera on mode hea ng zone(s)
L Display
M Opera on mode DHW
It‘s recommended to put the boiler
on 50% load a er the rst startup, as
this is the best star ng point to do a
proper combus on analysis. This can
be done with the following proce-
dure:
Push bu on I >3 Secs, the boiler
goes into controller Stop mode.
Push the Info bu on (G), the ac-
tual boiler load (%) appears in the
display;
Choose „set up“ (con rm with OK
bu on), now the boiler load can
be changed by rota ng the wheel
(C) and con rming the 50% set-
ng with the OK bu on.
LPG (G31) Se ngs
In order to operate with G31 gas
type reaching the related parameters
(9524 min. rpm and 9529 max. rpm)
on the display. Values of rpm are
listed on page 9:
• Push OK bu on
• Push (G) for 3 seconds
• choose installer with wheel (C)
• Push OK bu on
• choose branderautomaat with
wheel (C)
• Push OK bu on
• choose parameternumber you
want to change with wheel (C)
OK (parameter is blinking)
change value with wheel (C)
OK (parameter is stored)
A er checking the combus on val-
ues (see next page), the controller
Stop mode can be exited by pushing
the control mode bu on (I) >3 Secs.
Ini al procedures
To guarantee safety and the correct
opera on of the appliance, the boiler
must be prepared for opera on by a
quali ed technician who possesses
the skills which are required by law.
Electricity supply
Check that the voltage and fre-
quency of the electricity supply
correspond to the data shown on
the boiler data plate;
Make sure that the earthing con-
nec on is e cient.
Filling the hydraulic circuit
Proceed in the following manner:
Open the system lling point and
vent the hydraulic system. Con -
nue lling the system un l pres-
sure gauge on the boiler registers
1.5 bar
Gas supply
Proceed as follows:
Make sure that the gas supply de-
livers the same type of gas as in-
dicated on the boiler data plate;
ATTENTION: The Boiler is set for
G20-G25 gas type. To operate with
G31 gas type use the procedures
described on “LPG se ngs”.
Open all doors and windows;
Make sure there are no sparks or
ames in the room;
Make sure that the gas connec-
ons are sound.
Prepara on for rst startup
Open the gas supply;
Enable the power supply to the
boiler;
Switch on the boiler with the on/
o switch (A);
Make sure the boiler is in standby
mode ( );
Check the pump opera on: make
sure the pump runs in the right di-
rec on;
Release all air from the pump mo-
tor.
28

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Elco THISION L EVO bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Elco THISION L EVO in de taal/talen: Engels als bijlage per email.

De handleiding is 8,12 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info