561013
13
Verklein
Vergroot
Pagina terug
1/36
Pagina verder
Operating controls and connecting terminals
13
1. SUBWOOFER LEVEL
The subwoofer volume control should be adjusted to match the main speaker volume of your hifi or home
cinema system. As a general rule, subwoofer performance should not dominate the sound. Excessive
bass leads to a smeared soundstage and can result in unpleasant resonances at certain frequencies.
2. LOW-PASS CROSSOVER
Used to adjust the frequency at which the subwoofer crosses over. Signals above this crossover fre-
quency are gradually rolled off so they do not interfere with the main speakers. The adjustment of the
crossover frequency will depend on the size and frequency response of the main loudspeakers.
Loudspeaker configuration Crossover frequency
Home cinema set (5.1 …) with LFE channel 120 - 160 Hz
Hifi/Stereo system with very small loudspeak-
ers
80 - 120 Hz
Stereo system with satellites and subwoofer
(2.1)
80 - 120 Hz
Hifi/Stereo system with medium-sized book-
shelf speakers, smaller floor standing loud-
speakers (compatible with most ELAC loud-
speakers)
50 - 80 Hz
3. POWER
Provided on the rear of the subwoofer, there are three positions available:
AUTO: Normal position. The ELAC subwoofer is switched to standby mode (indicator light LED glows
red).
A sensor controls the inputs. If the appropriate bass signal is present, the power output stage is switched
on. Within tenth of a second, the subwoofer is ready for operation (indicator light LED glows green). The
subwoofer switches into standby mode again after a signal pause of more than 15 minutes (indicator light
LED glows red).
Note: If the automatic turn-on operation only responds to full volume, please increase the bass/LFE level
of your surround receiver and decrease the subwoofer level about the same amount. This way, there will
not be any changes in acoustical bass level and the subwoofer will be turned on automatically at a lower
volume.
ON: The subwoofer is operating continuously (indicator light LED glows green).
OFF: The subwoofer is held in standby mode continuously (indicator light LED glows red).
To switch off the subwoofer completely, please switch the MODE control to OFF. A second later, the
Power switch can be turned off without any noise.
4. LED
ON / Standby LED. Glows green when device is switched on; glows red when device is in standby mode.
5. PHASE
The acoustical phase relative to the input phase may be adjusted by means of the phase control knob.
The range is (in phase) to 180° (out of phase). The optimum adjustment should be determined within
the listening test. While going through the whole range of the phase control adjuster, the adjustment with
the highest bass output at the listening place should be kept.
13

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Elac SUB 2025 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Elac SUB 2025 in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 0,86 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info