561005
29
Verklein
Vergroot
Pagina terug
1/44
Pagina verder
Connection and starting 26
Important:
Should you intent to use the ELAC complete active subwoofer as a subwoofer alone,
-- without satellite speakers --, you can skip this chapter and continue at page 27, pt.3.
1 SAT OUT L
2 SAT OUT R
Note:
Especially suited as satellite speakers are ELAC 301 and ELAC Starlet.
These are available together with ELAC MicroSUB 2010 BT in 2 combination sets:
ELAC MicroMAGIC 2.1 (with 2 x ELAC 301) and ELAC MicroSTAR 2.1 (with 2 x ELAC Star-
let).
These combinations are perfectly tuned 2.1 speaker systems that guarantee great music
pleasure at minimum space.
But the ELAC complete active subwoofer is also suited for every other satellite speaker.
The internal filtering of lowest frequencies (<80 Hz) saves the satellite speakers from unnec-
essary load in favour of a more efficient and effortless reproduction of mid and high parts of
the spectrum.
The spring-type terminals SAT
OUT L/R allow the connection of 2
satellite speakers (Left, Right) to
the ELAC complete active
subwoofer. Here you can use the
included speaker cables, which go
to the satellites. For clarity the
figure at left shows the “+”-pole in
brighter colour. Of course you can
use other cables than the included
ones.
During cable insertion into the
cross-hole please take some care
in order to avoid short circuit
against the neighbouring clamp or
the housing. Typical HQ speaker
cables today have 2.5 mm² cross-
sections. 1.5 mm² types are sufficient without serious losses up to about 6 meters (20 feet)
with 4-Ohm speakers, and up to 12 meters (40 feet) with 8-Ohm speakers. For much shorter
distances (on the desktop) you can cut the cable and also use less cross-section cable
types.
The satellite speakers used should have “Nominal Impedance” not below 4 Ohms (3 Ohms
minimum). The impedance specification you should find printed on the rear side of the
speaker or the owners manual.
!!! Caution !!!
These Connections are “Outputs”, not “Inputs”.
They are suited solely for connection of passive loudspeakers. Connection to an amplifier
output could result in – worst case - damage to the active subwoofer and/or the amplifier!!!
29

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Elac SUB 2010 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Elac SUB 2010 in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 3,51 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info