Operating instructions for
right-angle grinders
The machine is light, handy, totally insulated and
designed in compliance with the international
specifications CEE 20. Provided it is serviced as
described in these instructions, the machine will
serve you for a long time.
VOLTAGE
Before you use the machine for the first time, check
that the voltage marked on the rating plate is the
same as your mains voltage. Under no
circumstances is the mains voltage to differ from the
rated voltage by more than 10%.
SWITCH
To help prevent accidents, the right-angle grinder is
equipped with a safety switch. To turn on the
machine, push the switch forward and push down
until it latches in place. To turn the right-angle grinder
off, push the switch down. It will then jump back to its
original position.
REPLACING THE GRINDING WHEEL
Pull out the power plug.
Simple wheel change by spindle
lock: Press the spindle lock and
allow the grinding wheel to latch
in place.Open the flange nut with
the face spanner.
Change the grinding or cutting
wheel and tighten the flange nut
with the face spanner.
Important! Only ever press the spindle lock
when the motor and grinding
spindle are at a standstill!
You must keep the spindle lock pressed while
you change the wheel!
For grinding or cutting wheels up to approx. 3 mm
thick, screw on the flange nut with the flat side facing
the grinding or cutting wheel.
TEST RUN FOR NEW GRINDING WHEELS
Allow the right-angle grinder to run in idle for at least
1 minute with the grinding or cutting wheel fitted in
place. Vibrating wheels are to be replaced
immediately.
MOTOR
It is vital for the motor to be well ventilated during
operation. Be sure, therefore, to keep the ventilation
holes clean at all times.
CARBON BRUSHES
Carbon brushes that are burned, b
than 5 mm are to be replaced by o
replacement brushes. Always rep
brushes in pairs.
GRINDING WHEELS
Never use a grinding or cutting wh
specified diameter.
Before using a grinding or cutting
rated speed. The wheel´s rated sp
higher than the idle speed of the r
Use only grinding and cutting whe
approved for a maximum speed o
peripheral speed of 80 m/sec.
OPERATING MODES
Rough grinding:
For the best rough grinding results
wheel at an angle of between 30°
workpiece surface and guide back
workpiece in steady movements.
Cutting:
When you use the right-angle grin
purposes, avoid tilting it in the cut
cutting wheel must have a clean c
A diamond cutting wheel is best u
stone.
It is prohibited to use the machine
materials!
Never use a cutting wheel for roug
TECHNICAL DATA
Nominal voltage:
Power consumption:
Idle speed:
Max. wheel diameter:
Drive spindle thread:
Sound pressure level LPA:
Sound power level LWA:
Vibration
a
–
w
Weight
Totally insulated
