6.1 Switching on the appliance
With the main ON/OFF switch (Fig. 1/Item 6) the
appliance is cut off completely from the power supply.
Switch the main switch on first, and off last when you
no longer need the appliance.
After the main switch is switched on, the equipment
will be in standby mode. With the On/Standby button
(Fig. 1 / Item 5) you can switch the equipment on or to
standby mode.
6.2 Heating mode
If the On/Standby button (Fig. 1/Item 5) is pressed,
the equipment will be switched on, the lowest heat
output will be set, and on the display will appear the
current equipment temperature in the area of the
integrated temperature sensor and two bars.
If the "▲" button is pressed, the highest heat output
will be switched on and four bars will appear on the
display. If the "▼" button is pressed, the equipment
will be reset to the lowest heat output.
6.3 Timer function
Note: An OFF time from 1 – 24h can be set.
Set heating mode as described above. Press the
"Mode" button. A "clock" symbol will appear and the
currently set time will flash on the display. The
selected time can be increased by pressing the "▲"
button. The selected time can be decreased by
pressing the "▼" button. To switch off the time
selection, press the "Mode" button again and press
and hold the "▼" until "00" appears, or press the
On/Standby button.
6.4 Setting the desired temperature
Note: A desired temperature from 5 – 36°C can be
set.
Set heating mode as described above. Press the
"Mode" button twice. A "thermometer" symbol will
appear and the currently set temperature will flash on
the display. The selected temperature can be
increased by pressing the "▲" button. The selected
temperature can be decreased by pressing the "▼"
button.
6.5 Switching on the ionizer
The ionizer is switched on and off with the button (4).
A symbol appears on the display when the ionizer is
ON.
6.6 Overheating guard
In case of excessive heating, the appliance shuts
down automatically. If this occurs, turn off the
appliance, disconnect the mains plug and wait a few
minutes for the appliance to cool. After eliminating the
cause (e.g. a covered air grille), the appliance can be
switched on again.
7. Maintenance and cleaning
n Before carrying out any cleaning and
maintenance work the appliance must be turned
off, disconnected from the power supply and
cooled down.
n Maintenance and repair work may only be carried
out by an authorized electrical servicing
contractor or ISC GmbH.
n Check the mains lead at regular intervals for signs
of defects or damage. A damaged mains lead
may only be replaced by an electrician or ISC
GmbH in compliance with the relevant
regulations.
n Use a damp cloth to clean the casing.
n Remove dust pollution with a vacuum cleaner.
8. Storage
The heater has to be stored in a dry place, covered if
possible.
9. Ordering spare parts
Please provide the following information on all orders
for spare parts:
n Model/type of the appliance
n Article number of the appliance
n ID number of the appliance
n Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
GB
10
