26
3. Assembly of the outdoor device
Have the connection cable for the outdoor device
connected only by a qualified electrician
4. Connecting the coolant tubes
4.1 Important notes
Please make sure that coolant is never allowed
to enter the environment.
Improper handling of coolant may be harmful to
health. Always wear work gloves and goggles
when handling coolant.
Make sure that the work place is well ventilated
at all times. Smoking is prohibited.
The device must never be operated without the
coolant tubes connected, otherwise the device
will be damaged immediately.
Ask one of our service partners or a specialist
cooling system firm to connect the coolant lines
and put the system into operation for the first
time.
5. Remote control holder
Before you mount the holder, check that the remote
control can be received by the indoor device from the
planned location for the holder. Do not select a
position in direct sunlight or in the vicinity of any
sources of heat.
Check that the + and – terminals on the batteries
are positioned correctly in the remote control.
Fasten the remote control holder to the wall with
dowels and screws.
Electrical connections
1. Remove the fresh air connection part.
2. Remove the connection terminal and
connect the mains cable to the connection
element with the screws. Make sure that
the wiring conforms with the indoor device.
3. Fix the wires in position with the terminal
and make the necessary connections.
4. Check once again that connections are
really secure.
5. Re-fasten the fresh air part.
Note:
A wrong electrical connection can cause
faults in the electrical system. Do not pull
on the cable when you connect it to the
terminal.
Important
1. Have all service work performed by a specialist
firm only. Request a copy of our list of service
partners for any such work.
2. If ever the voltage carrying cable between the
indoor device and the outdoor device should be
damaged, contact a specialist firm.
3. If the power cable should ever be damaged,
have it replaced by an electrician.
4. Important note:
a) The maximum length of the coolant line in the
basic version is 4 meters.
b) If the outdoor device is higher than the indoor
device, a curve will be required in the coolant
tube which is positioned below the height of the
indoor device.
