11
GB
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
5. Before starting the equipment
Be sure to read the following information before you
use your cordless screwdriver for the first time:
1. Charge the battery pack with the charger
supplied.
2. Only ever use screwdriver bits which are suitable
for the purpose and in faultless condition.
3. Always check for concealed electric cables and
gas and water pipes when drilling and screwing
in walls.
6. Operation
6.1 Charging the battery (Fig. 2)
1. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger.
2. Plug the mains plug of the charger into the mains
socket outlet and place the cordless screwdriver
on the charger. The charging process starts as
soon as the cordless screwdriver lies on the
charger.
3. The red LED (7) will come on to indicate that the
battery pack is being charged.
Important. It does not switch off automatically when
fully charged!
Disconnect the charger from the mains socket when
charging is completed. Note the maximum charging
time (see section 4).
Important! The handle may become a little warm
during the charging process. This is normal.
Important. The storage box is not allowed to be
closed during the charging process.
If the battery pack fails to charge, please check
whether there is voltage at the socket-outlet
and check for proper contact with the charging
contacts in the battery charger.
If the battery still fails to charge, send
the battery charger
and the screwdriver
to our customer services department.
Timely recharging of the battery pack will help it
serve you well for a long time. You must recharge
the battery pack when you notice that the power of
the screwdriver drops.
Never allow the battery pack to become fully
discharged. This will cause it to develop a defect.
6.2 Changeover switch (Fig. 3/Item 10)
The slide switch above the ON/OFF switch is for
setting the direction of rotation of the cordless
screwdriver and for preventing the cordless
screwdriver from being switched on inadvertently.
You can select between clockwise and counter-
clockwise rotation. Change the direction of rotation
only when the equipment is at a standstill. If you fail
to observe this point, the gearing may become
damaged. When the slide switch is in the middle
position, the cordless screwdriver cannot be switched
on.
6.3 ON/OFF switch (Fig. 4/Item 9)
Press the On/Off switch to switch the cordless
screwdriver on. Release the ON/OFF switch to
switch off the tool.
6.4 LED lamp (Fig. 5/Item 2)
The LED lamp (2) can be used to additionally
illuminate the screwing position.To switch on, push
the switch (4) forwards; to switch off, pull the switch
back again.
6.5 Angle adjustment (Figure 6-7)
The handle (8) of the cordless screwdriver can be
locked in both end positions.
Press the release button (6) to adjust the handle.
Keeping the release button pressed, you can then
turn the handle into the required position.
Important. Before you switch on, make sure that the
handle is securely locked in the required position.
6.6 Battery capacity indicator (Fig. 8/Item 5)
Press the button for the battery capacity indicator (a).
The battery capacity indicator (a) indicates the
charge state of the battery on 3 colored LEDs.
All LEDs illuminate:
The battery is fully charged.
The yellow and red LED illuminate:
The battery has an adequate remaining charge.
Red LED:
The battery is empty, recharge the battery.
