13
GB
5.3 Changing the sanding / grinding belt
(Fig. 6-7/Item 13)
n Pull the clamping lever (12) to the outside to
relieve the tension in the sanding/grinding belt.
n Pull the used sanding/grinding belt off the drive
rollers.
n Slide the new sanding/grinding belt on to the
drive rollers.
n Ensure that the direction of the sanding/grinding
belt (arrows on the inside of the sanding/grinding
belt) is identical to the direction of the belt
sander/grinder (arrow over the rear drive roller).
n Press the clamping lever (12) to the rear to
tension the sanding/grinding belt.
5.4 Adjusting the position of the belt
(Fig. 8/Item 8)
n Hold the belt sander/grinder with the
sanding/grinding plate at the top.
n Switch on the belt sander/grinder.
n By turning the setting screw (8) the belt position
should be set so that the sanding/grinding belt is
at the center of the two drive rollers.
5.5 Moving sanding/grinding belt cover
(Fig. 9 – 10/Item 9)
Important.
The moving sanding/grinding belt cover may
only be swung upwards if the pushbutton (7) has
been pressed.
n Press the pushbutton (7) and at the same time
swing the cover (9) upwards.
n Release the pushbutton.
n The cover will lock in its end position.
n To swing the cover back down again, press the
pushbutton (7) again. The cover can then be
swung downwards.
6. Starting up
6.1 Switching ON/OFF (Fig. 11)
To switch on:
Press the ON/OFF switch (5).
Continuous operation:
Secure the switch (5) with the locking button (4).
To switch off:
Press the ON/OFF switch (5) briefly.
The machine can be operated on a temporary or
permanent setting.
6.2 Setting the belt speed (Fig. 12/Item 3)
You can select the belt speed by turning the setting
knob (3).
PLUS direction:
Increase belt speed
MINUS direction:
Reduce belt speed
6.3 Instructions for use
Important. Never hold the workpiece you wish to
sand/grind in your hands. Secure the workpiece on a
sturdy surface or using a vise.
n Allow the belt sander/grinder to start before you
place it on the workpiece.
n Do not switch off the belt sander/grinder as long
as the sanding/grinding belt is in contact with the
workpiece.
n Always hold the belt sander/grinder with both
hands whilst it is in use.
n Always sand wood in the direction of the grain.
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
n Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
n We recommend that you clean the device
immediately each time you have finished using it.
n Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
