GB
14
damaged. All parts must be fitted correctly and
satisfy all conditions for the tool to work properly.
Unless otherwise stated in these instructions,
damaged safety devices and parts must be
repaired or replaced by experts in an approved
specialist workshop.
Have damaged switches replaced by a customer
service workshop.
This tool complies with the pertinent safety
regulations. Repairs are to be carried out only by
qualified electricians using original replacement
parts. The user may suffer an accident if this
condition is not observed.
The machine is to be operated only with tools
which conform with EN 847-1:2003.
Pull out the power plug and twist the blade with
your hand into the 45° and 90° positions in order
to make sure that the blade does not touch the
turntable in any position. If necessary, readjust
the saw head.
If the table insert is worn, replace it.
Never use blades made of high-speed steel
(HSS).
When cutting miters, make sure that the device
for swiveling the arm is fastened securely.
Be careful when working in vertical mode.
Caution: Take extra care when making double
miter cuts!
Do not overload your tool.
Wear safety goggles.
Use a dust mask when working on dusty jobs
Check the tool cable/extension cable for damage.
Always wear gloves when handling saw blades
Wear goggles
ᏟWear ear-muffs
Wear a breathing mask
Noise emission values
The saw’s noise is measured in accordance with
DIN EN ISO 3744; EN 60651; 6/93, ISO 7960
Annex A; 2/95. The machine may exceed 85 db (A)
at the workplace. The user will require noise
protection measures if this is the case. (Wear ear-
muffs!)
Sound pressure level LPA 95,9 dB(A)
Sound power level LWA 108,9 dB(A)
„The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immision level
at the workplace include the duration of impact, the
type of room, and other sources of noise etc., e.g.
the number of machines and other neighbouring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved.“
5. Technical data
Asynchronous motor 230 V ~ 50 Hz
Output 1600 W
Operating mode S1
Idle speed n04200 min-1
Carbide-tipped saw blade ø 305 x ø 30 x 3.2 mm
Number of teeth 60
Tilting range -45° / 0° / +45°
Mitre cuts 0° to 45° to the left
Saw bed support 522 x 171 mm
Sawing width at 90° 330 x 102 mm
Sawing width at 45° 230 x 102 mm
Sawing width at 2 x 45°
(double mitre cuts) 230 x 65 mm
