Fitting the cuttings collector (Figure 3a-3d)
For horizontal cutting we recommend that you install
the cuttings collector. This enables you to remove the
cuttings easily. The surface of the hedge thus remains
clear (Fig. 3a/3b).
Position the cuttings collector (9) on the cutter rail
(Figure 3c). Then push the cuttings collector as far as
possible towards the tip of the cutter rail and secure it
with the fastening screws (8) (Figure 3d). The cuttings
collector can be fitted on either the right or left side.
7. Operation
The hedge trimmer is equipped with a two-handed
safety switch. The equipment works only when the
switch on the steady grip (Figure 4 / Item A) is
pressed with one hand and the switch on the handle
(Figure 4 / Item B) is pressed with the other hand. If
either switch is released, the cutters will stop moving.
Please watch out for the cutters as they slow
down to a standstill.
n Please check that the cutters work properly. The
twin-bladed cutters rotate in opposite directions,
thus guaranteeing high cutting performance and
smooth operation.
n Before use, fasten the extension cable in the
stress-relief clip (see Fig. 4).
n When working outdoors, use extension cables
that are approved for the purpose.
Notes on working practice
n A hedge trimmer can be used to cut shrubs and
bushes as well as hedges.
n To obtain the best cutting results, hold the hedge
trimmer so that the cutter teeth are at an angle of
approx. 15° in relation to the hedge (see Figure
5).
n The twin-bladed cutters rotate in opposite
directions, thus enabling cutting in both directions
(see Figure 6).
n It is recommended to tie a guide line of string or
the like along the hedge so that you cut the hedge
to a level height. Cut off all branches which
protrude beyond the guide line (see Figure 7).
n Cut the sides of the hedge with curve-shaped
movements from the bottom up (see Figure 8).
8. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
9. Cleaning, maintenance and ordering
of spare parts
Always pull out the power plug before starting any
cleaning work.
9.1 Cleaning
n Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
down with compressed air at low pressure.
n We recommend that you clean the equipment
immediately after you use it.
n Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the equipment. Ensure that no
water can get into the interior of the equipment.
9.2 Servicing
n The cutters should be cleaned and lubricated at
regular intervals in order to ensure best
performance at all times. Remove deposits with a
brush and apply a thin film of oil (see Figure 9).
n There are no parts inside the equipment which
require additional maintenance.
9.3 Ordering replacement parts
Please provide the following information on all orders
for spare parts:
n Model/type of the equipment
n Article number of the equipment
n ID number of the equipment
n Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
14
GB
