5. Technical data:
Rated voltage: 220-240 V ~ 50 Hz
Heat output: 1500 W
Protection type: IP 55
Appliance dimensions, approx.: 60 x 60 x 110 cm
6. Before starting the equipment
6.1 Assembly (Fig. 2-3)
Warning!
The equipment is allowed to be used only when
standing on a stable surface and fully assembled. It is
prohibited to operate the equipment on an instable
surface (e.g. on a bed).
n Screw the lower stand pipe (2) to the base plate
(4) using 3 Allen screws M8x25 (A). To do this,
use the supplied 5mm Allen key (B).
n Screw the table top (1) to the stand pipe (2) using
4 Allen screws M6x12 (C). To do this, use the
supplied 4mm Allen key (D).
The heater is now fully assembled and ready for
operation.
7. Using the equipment
Important. Before using the equipment for the first
time, check that the voltage supply is the same as the
voltage details set out on the rating plate. Read the
safety regulations in section 1.
When the equipment is used for the first time or after
a long period of rest, it may emit an odor for a short
time. This is not a fault.
If black spots appear on the heating elements during
the first minutes of operation, this will affect neither
the quality nor performance of the heater.
7.1 Topple cut-out
The equipment has a topple cut-out. This will trip as
soon as the device is tipped beyond certain angle. It
will cut in again after the device has been placed
upright.
7.2 Switching On and Off (Fig. 1)
Use the On/Off switch (3) to switch the heater On
(position I) or Off (position 0).
8. Replacing the power cable
Danger!
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
9. Cleaning, maintenance and ordering
of spare parts
9.1 Cleaning
Danger!
n Before carrying out any cleaning and
maintenance work the equipment must be turned
off, disconnected from the power supply and
cooled down.
n Maintenance and repair work may only be carried
out by an authorized electrical servicing
contractor or ISC GmbH.
n Use a damp cloth to clean the casing.
n Remove dust pollution with a vacuum cleaner.
n Never use combustible cleaning agents.
n To remove dust on the safety grille and heating
elements, use a brush with long soft bristles.
n In cases of very stubborn dirt the appliance
should be cleaned by a professional.
9.2 Servicing
There are no parts inside the equipment which
require additional maintenance. If the heating
elements have to be replaced, please contact your
customer service center.
9.3 Ordering spare parts
Please provide the following information on all orders
for spare parts:
n Model/type of the equipment
n Article number of the equipment
n ID number of the equipment
n Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
10. Fault
In the event that the heating elements do not produce
heat, check if the equipment is switched on. If the
household fuse or e.I.c.b. has tripped, please ensure
that no other high-power devices are loading the fuse
in addition.
10
GB
