11
GB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values determined in accordance with
EN 60745.
Vibration emission value a
h
= 6.39 m/s
2
K uncertainty = 1,5 m/s
2
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment’s
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Fitting the dust bag (Figure 2/Item 6)
Place the dust bag (6) on the dust bag connector (4)
and secure it by turning it.
The dust is extracted directly through the
grinding/sanding paper and the grinding/sanding disk
and into the dust bag.
Important. For health safety reasons it is imperative
that you use a dust bag.
5.2 Securing sanding/grinding paper using a
clamp (Fig. 3-6)
Only use sanding/grinding paper of the appropriate
size and suitable perforations.
Lift the lever (8) on the front of the orbital sander.
Insert the sanding/grinding paper as far as
possible into the open clamp and close the lever
again.
Place the sanding/grinding paper taut over the
orbital plate (7) and clamp it again using the
second lever (8) on the rear of the orbital sander.
Make sure that the perforations in the
sanding/grinding paper line up with the oscillating
plate.
5.3 Fastening the sanding/grinding paper with
the Velcro fastening system (Fig. 7)
Only use sanding/grinding paper with the
corresponding dimensions and matching
perforations.
Place the sanding/grinding paper onto the
oscillating plate (7) as shown in figure 7. Make
sure that the perforations in the sanding/grinding
paper coincide with the oscillating plate.
6. Operation
6.1 Switching the machine on and off
(Fig. 8/Item 2)
To switch on:
Slide the operating switch (2) forwards.
To switch off:
Slide the operating switch back into its initial position.
6.2 Speed control (Fig. 9/Item 3)
To pre-select the speed turn the knurled screw (3) on
the switch.
