6
GB
Description
1 Quick-change drill chuck
2 Depth stop
3 Additional handle
4 Selector button: drill/hammer
5 Rating plate
6 Selector button: clockwise/anticlockwise
7 Speed control
8 Locking button
9 On/Off switch
Technical data
Voltage: 230 V ~ 50 Hz
Power rating: 1100 W
Drilling capacity Concrete 16 mm
Steel 13 mm
Wood 32 mm
No Load Speed 1. Gear 0 - 1100 min
-1
No Load Speed 2. Gear 0 - 3000 min
-1
Number of blows 1. Gear 0 - 16.500 min
Number of blows 2. Gear 0 - 45.000 min
Safety insulated II / Ɓ
Sound pressure level LPA 89,7 dB(A)
Sound power level LWA 102,7 dB(A)
Vibration a
w
9,25 m/s
2
Weight 3,4 kg
Caution
● The BM-G 1100 E is not designed for the
operating of auxiliary devices.
● Do not use near steams or inflammable liquids.
● Only use sharp bits and suitable screwing bits.
● Remove the plug from the socket for all adjusting
and cleaning work.
● Protect the mains cable against any damage. Oil
and acids can damage the cable.
● Do not carry the device by the mains cable.
● Do not remove the plug from the socket by pulling
the mains cable.
● Make sure before inserting the plug that the
operating switch is not locked.
● When using a cable drum uncoil the cable com-
pletely. Cross-section of wire at least 1,5 mm
2
.
● Do not overload machine.
● Secure all workpieces to be processed sufficiently.
● Do not allow children to have access.
● Make sure you have a secure stance on ladders or
scaffold-ing when using the drill freehand.
● Localise lines with a line detector in walls where
power, water or gas lines are laid invisibly.
● Wear protection goggles and use a dust mask for
dust-producing work.
● Always arrange for a qualified electrician to carry
out repairs
● Use only original replacement parts
● The level of noise at the workplace may exceed 85
dB(A). In this case you will need to introduce noise
protection measures for the user. The noise
generated by this electric tool was measured in
accordance with ISO 3744, NFS 31-031
(84/537/EEC).
● Vibration measured on the handle acc. to ISO
8662-8.
Maintenance
● Always keep the drill clean.
● Do not use corroding agents for cleaning plastic.
● Check carbon brushes in the case of excessive
sparking.
● Keep ventilation channels free.
● If you discover any damage, you can contact our
Customer Service for replacement parts.
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Ȝ Type of machine
Ȝ Article number of the machine
Ȝ Identification number of the machine
Ȝ Replacement part number of the part required
Replacement part Replacement part number
Carbon brush 42.597.20.01
Switch 42.597.20.02
