Handleiding Einhell AKKU 1000 (pagina 11 van 60) (Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Deens, Zweeds, Noors, Fins)

724273

Verklein

Vergroot

Pagina terug

1/60

Pagina verder

20) When working on a slope us the mower

transversally rather than up and down and take

great care when turning.

21) Never us the mower on more than a 15%

gradient

22) Before lifting the mower, switch off the motor,

remove the safety key and wait for the blades to

come to a standstill.

23) Never allow children, other persons or animals

near to where you are working. Always keep

them at least 10 metres from the work area.

24) Before returning the mower to a dry storage, out

of the reach of children, always remove the

safety key.

ELECTRICAL SAFETY RULES

1) The supply voltage for the battery charger must

correspond to the voltage stated on the technical

data plate (230V~50Hz). Do not use other

sources of power.

2) Avoid damaging or treading on the battery

charger cable when this is operating.

3) Do not use the battery charger in damp

environments or on wet surfaces.

4) Do not short-circuit the battery as it may explode.

5) If the battery breaks and you come into contact

with the acid, rinse the affected parts with plenty

of water.

The battery charger has been built with dual

insulation in compliance with EEC 20 regulations.

Dual insulation is electrically safer and therefore the

battery charger does not need earthing.

ASSEMBLY OF COMPONENTS

When the lawnmower is supplied, some parts are

provided loose and require assembly. Assembly is

quite simple if the following recommendations are

respected.

During assembly of the components, the motor

should be off and the safety key removed from the

switch.

1. THE HANDLE

Take the lawnmover out of its box which also

contains the three parts of the handle. Insert the two

curved handles into position and make sure that the

holes for the screws are facing outwards. Take two

screws from the bag to fasten the handles to the

casing (fig. D). Insert the two caps in the top ends of

the handles (fig. D).

Attach the upper handle by fastening it with the two

M8x45 screws and the handwheels provided (fig. F).

2. THE GRASSBOX

Fit the upper grassbox to the lower grassbox,

pressing the clips together (fig. C).

Before mounting the grassbox onto the mower make

sure that the motor is switched off and the blade is

still. Lift the guard flap and hook the grassbox onto

the clips on the casing.

CUTTING HEIGHT ADJUSTMENT

Turn off the motor and remove the safety key before

adjusting the cutting height.

Adjustment is carried out on the wheels (fig. E). The

mower has three cutting heights: 30, 45 and 60 mm.

The wheels should be positioned so that the mower

is on a level.

BATTERY CHARGING

The battery has been charged before delivery in

order to achieve total cutting power and it should be

recharged before operation. Only the battery

charger supplied with the mower should be used.

Further charging is necessary:

a) After each cutting operation (even if some

charge remains)

b) Before storing the battery away for the winter

c) When the battery has not been used for a long

time (over 6 months)

Battery recharging

a) Remove the handwheel (fig. A pos. 9) and the

cover

b) Disconnect the battery of the mower and place

it in a dry place out of reach of children (fig. E).

c) Connect the battery socket to the plug of the

battery charger, making sure that this is fitted

properly.

d) Then connect the battery charger to the

electricity mains supply.

To avoid damaging the battery, do not charge it for

more than 48 hours.

STARTING THE LAWN MOWER

To avoid accidental starting of the lawn mover, the

switch unit has been a safety button (fig. H pos 1)

that must be pressed before pulling the starting lever

(fig. H pos. 2). When this operation is carried out, a

“click” of the switch can be heard.

Insert the safety key in the switch unit (fig. F pos. 1).

Press the safety button and pull the lever, the motor

will start. When the lever is released, the button will

return to its initial position and the motor will stop.

This operation should be repeated a few times

before starting to cut the grass to make sure

everything is running correctly.

Anleitung Akku 1000 12-spr. 06.11.2001 11:43 Uhr Seite 11

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Einhell AKKU 1000 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info