810849
24
Verklein
Vergroot
Pagina terug
1/80
Pagina verder
- 24 -
ENGLISH
WARNINGS
Installing Firebox®
Besides the contents of this document,
please take into consideration the UNI stand-
ards:
- no. 10683 - Wood-Burning Heating Appli-
ances: Installation Requirements.
- no. 9615/90 - calculation of the inner di-
mensions of replaces.
Speci cally:
- before starting any installation operation,
it is important to check the compatibility of
the system as established by the UNI 10683
standard.
- after installation, the installer must "start-
up" the system and issue the documentation
required by the UNI 10683 standard.
Using Firebox®
Smoke damper adjustment: in the event of
dif culty clearing the smoke (low draught),
evacuation can be improved by adjusting the
screw on the damper control rod.
By turning the screw (clockwise) and closing
the door, the damper will remain slightly in-
clined, helping the smoke to ow out.
Ash tray: during operation, it must always be
completely closed; otherwise a "forge effect"
is created with consequent damage to the
Firebox® structure and covering components.
Efficiency and fuel consumption: to obtain
the declared ef ciency, it is necessary to burn
3.5 - 4 kg/h of wood (depending on the model
as shown in the technical speci cation table);
use with an excessive amount of wood may
cause damage.
When Firebox® is running at full power, it gen-
erates a signi cant amount of heat. There-
fore, during installation, carefully check that
there are no areas of contact with wood or
other combustible materials and that any
such materials are out of range of the heat
which radiates from the replace.
There should be insulation between Firebox®
and these materials or a gap of at least 3 cm
with free air ow, to prevent excessive heat
build-up.
Special front protection panels are available
for beams on request.
Electrical connections
(for forced ventilation versions)
- These must conform to professional installa-
tion and construction standards.
- The electrical components are always live;
before any maintenance, disconnect the plug
and turn off the electrical panel of the dwell-
ing.
- Avoid contact between electrical wires, Fire-
box® and the ue.
- The electrical equipment supplied with Fire-
box® must not be tampered with in any way.
For further details, con-
sult the following document:
“Firebox® Instructions for use" attached to the
product.
EXTERNAL AIR INTAKE (Figs. A-B)
The connection with the outside, made with
a cross-sectional area of at least 80/200 cm²
(depending on the model) is absolutely es-
sential, as prescribed by the standard gov-
erning installation requirements (UNI 10683).
It must, therefore, be provided.
It is made with a duct that must bring outside
air directly to the adjustment mechanism
(Fig. B). The regulation mechanism must be
attached to the bottom of Firebox®.
During installation, carefully seal the points
where the external air may leak.
The external air duct may come from behind,
from below, from the side, or consist of a ex-
ible hose which runs directly from the outside
to the mechanism vent (Fig. B).
It is advisable to apply a protection grille on
the outside of the air-intake duct that does
not, reduce the air- ow capacity.
The external air must be drawn in at oor
level.
If it is not possible to do as described above,
place the external air intake as near to Fire-
box® as possible.
SUPPORT STAND
UNIVERSAL OPTION (Fig. L)
Screw the 2 frame-fastening brackets (A) to
the bottom of the Firebox® structure, using
the ø 3.6 holes and the six 4.8x13 screws
provided.
At the pre-cuts, cut the vertical tubes of the
support frame (B) to the desired height for
positioning Firebox®.
Using the pins provided, t the frame (B) to
the brackets (A) previously fastened to Fire-
box®.
Take care that the horizontal projections (C)
of the frame are on the rear facing the wall.
Lock the support stand with the four 8x40
screws provided.
Position Firebox® with stand and fasten to
the oor using the anchors and 8x70 screws
provided.
FLUES (Fig. N)
The Firebox® smoke outlet has a circular
cross-section. It is provided to allow the use
with EdilKamin stainless steel pipes (rigid sin-
gle-wall or insulated rigid double-wall), that
allow a quick, secure connection to the ue.
If the ue inlet is not
vertical in relation to the
replace, the connection between the re-
place and ue must not narrow or slope by
more than 45° (1-3).
In the case of old or oversized ues, it is
advisable to line them with stainless steel
pipes of a suitable diameter and with suit-
able insulation. For ues located outside, we
recommend using the stainless In the case of
outdoor ues, it is advisable to use insulated
double-wall stainless steel pipes.
The constructional features, in particular as
regards mechanical strength, insulation and
gas-tightness, must be able to withstand a
smoke temperature of at least 450 °C.
Use high temperature mastic to seal where
the steel pipe connects to the Firebox®
smoke outlet.
Using the rigid, stainless steel ue requires a
female-female tting on the smoke outlet of
the replace.
The chimney pot should be placed in full wind.
FIREBOX® Installation Instructions
Fig. N
Fig. A
Fig. B
AA
BB BB
C
C
Fig. L
24

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Edilkamin Firebox Deco bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Edilkamin Firebox Deco in de taal/talen: Duits, Engels, Frans, Italiaans, Portugees, Spaans als bijlage per email.

De handleiding is 2.51 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Edilkamin Firebox Deco

Edilkamin Firebox Deco Gebruiksaanwijzing - Deutsch - 28 pagina's

Edilkamin Firebox Deco Gebruiksaanwijzing - English - 24 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info